I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hi,
We are considering a modem delta FOTA on our 9160 devices in field, but find two "approaches" described to this; Either using the modem AT command set ( AT #XFOTA=2...
Hi, Im using a custom NRF52811 board and on this board we are using the internal RC as LFCLK source. I have a single thread that sleeps every 10 seconds, so during 10 seconds...
Hello Nordic,
Currently, we are looking the stack architecture of the BLE provided in the attached link https://docs.nordicsemi.com/bundle/ncs-latest/page/zephyr/connectivity...
Hi I am currently working with nrf5340 board to create Custom BLE profiles for data transfer to mobile app. I am not finding any document or videos that gives me a detailed...
Hello,
In an application with the nRF52832, Softdevice and SDK 17.1.0 I try to use the temperature sensor according to the peripheral example. I attach the temperature.c...
Hi,
when I have the nRF Connect for VS Code Extension Pack installed locally it will break Dev Containers. The following error message will be shown when I try to run...
Hello everyone,
I'm trying to use the buttonless dfu functionality on nRF52 DK. However, I can't seem to test the functionality when there is no bootloader flashed, but...
Dear sir/madam
I'm designing the custom PCB for bluetooth application. I have some doubt on 50 ohm RF line. How to maintain that 50 ohm in track.
Kindly support regarding...
Hi, I have followed the nRF Connect SDK Fundamentals and BLE Fundamental courses and come to Lesson 6 Bluetooth LE sniffer. Everything has worked until this but now I get...
Hi,
In nRF52811-CAA chip, which pins are allocated to ADC inputs. In Table 122 of datasheet which shows pinout for WLCSP package, it just mentions AIN1, AIN2, and AIN3....
Hi,
I am facing an issue while flashing the code using an external debugger. I want to flash an LED blink code on the I/O shield " Raytac MDBT53V-P1M. " For this, I am using...
