Hello, I’m trying to compile code for a u-blox C209 AOA Tag. I installed the nRF Connect Extension Pack and was able to build normally.
After adding some unrelated paths...
This stopped working for me... Error is the following
Command failed: git ls-remote --tags --heads github.com/.../sdk-nrf
fatal: unable to access ' github.com/.../'...
Hello,
After a lot of efforts I managed to autoprovision and autoconfigure my nrf52840 board (provisioning and configuring inside the software and not through external app...
Hi there,
I am trying to interface at25xe321d with QSPI but it always end up returning zeros. Please find attached code and dts file for reference. Thanks Moh
When version 1.0.0 of nRF54L15-DK evaluation kit will be available and how to distinguish the version when ordered from distributors like Digikey?
In discussion here:
...
-> How to transfer data from one thingy52 device to another thingy52 device. If i have 2 thingy52 devices, I'll send data to 1st tingy52 then 1st thingy52 device will send...
Dear devzone，
Based on ncs2.9.1 and nRF54L-DK(v0.9.2), add in the prj.conf of the peripheral_uart example:
Compile and burn to nRF54L15-DK, the program does not run, and...
I'm using SDK 11 on my nrf51 chip. I'm trying to output a 120hz pwm but it doesn't seem to be producing at 120hz. I have a 120hz signal i'm trying to match and it blows pass...
Dear Wang,
I am unable find any documentation and board Initialisation code on how to change PIO from analog to digital output. but can't seem to locate the setting.
...
Hi,
I am working with MLX90615 sensor and is working with nrf_drv_twi functions and I could collect data as well. Now I need to put the sensor to sleep mode. Entering to...
Hi,
I'm trying to connect DWM1000 with SPI using spi_master.h.
When I have written to registry e.g. 0x11, 0x12 and read it I've got bytes: 0xFF, 0x11.
If I read three bytes...
Hi
I'm wondering if anyone have had any success or problems with generating and using secure DFU keys under Linux?
I'm using the latest nrfutil from: github.com/......
i am using nrf52832 pca10040. i tried to run the ble blinky example from package installer. it compiles without any error, but when is load it to the DK it will not even advertise...
NRF52832 is bluetooth pre approved SoC. So still need to pay Buetooth SIG to sell my Bluetooth based product in INDIA ???
Can i Sell non Certified product Without FCC CE...
Hi Nordic Forum!
Looking for the right configuration for the connection parameters, found different references to this Apple guide .
The problem is that in the 3rd condition...
I'm working on a project where I need to recognize whether or not a wireless tag is within 5-10' of a stationary reader. I would develop the reader system using a module,...
Hello,
I am using IAR Embedded Workbench for ARM ver 7.6. We are using nrf52 with SDK 11 and the corresponding soft device.
We are having a problem with the uart sending...
we have
/**@brief Function for initializing BSP.
*
* @details The function initializes the board support package to allow state indication and
* button reaction....
Hi,
I'm trying to connect to a Raspberry Pi from an nRF52832 via BLE Central mode. The Pi is running a node.js app (via bleno) and I can connect and communicate with it...
