Hi: The device shows successful reconnection, but the mobile end is not connected.
And the connection information displayed on the device is (public), which is actually...
I am trying to measure the 300mA system current.
I cut off the system lane and connected Vin, Vout.
And when in ampere mode, the system is not turning ON.
(When I replaced...
Hi Nordic,
I have a custom board using a Raytac MDBT53 module with nRF5340. The board is designed for 3.3 V / LDO mode, but during bring-up I likely flashed firmware/configuration...
Hello Nordic support,
I am using two nRF54L15 devices with NCS v3.0.1 and ESB DPL at 1 Mbps. Auto ACK is enabled, the payload is 252 bytes, and the retransmit count is 9...
# SoftDevice Controller assert during DTM receiver test at dead/marginal RF link (nRF52833) ## Summary On an nRF52833, running the nRF Connect SDK Direct Test Mode (DTM) 2...
A customer implemented a nRF52840 (QIAA package) and says the output power is about 10dB lower than expected. Having done multiple nRF52 designs with good results, I reviewed...
While configuring a scene, the blind device is not visible in the scene settings screen, so it is not possible to set or save the blind position as part of the scene.
Steps...
Hi!
I am trying to test the CLI over BLE example. I want to use it in another application for logging data to a laptop console over BLE.
However, I am having trouble following...
Hi,
We are using NRF52832 MCU for one of our BLE based project.
We are running out of memory when specific operation performed. Buffer crashed.
What is minimum setting...
I was using log to print debugging information when the BLE_GATTS_CFG_ATTR_TAB_SIZE message popped up. It doesn't normally happen. What's the reason for that? Thank you very...
After flashing the nRF-9160-DK with the required firmware ( as instructed in this video https://www.youtube.com/watch?v=rMvW3HXLErk&feature=youtu.be ), the LED 3 is flashing...
Hello,
we need to disable UART0 to achieve low power operation of our device. This is done by running:
This works correctly on a minimal example when building using...
Hi ,
I want to know if it is possible to interface NFC text record example with ble_app_uart example. I want to run both the programs simultaneously. As the NFC text record...
Dear all,
The forum is full of questions around printing floating point numbers, however, I have a rather strange issue where maybe someone can help.
I have a project...
Hi,
I am new to creating project from scratch.
I want to use nRF51802 module. From few support tickets i have come to know that SDK version 12.3 and SoftDevice S130 version...
This is a beginner question and may well related to a misplaced setting in Segger Embedded Studio.
I am working towards a BLE scanner application which will include NFC...
Hi, Thank you for your attention to this matter.
Please provide nrf5340 layout in this package to me: WLCSP 4.39 x 3.994 mm package The customer needed to use this encapsulation...
I want to receive more than 250 bytes over NUS ,presently i have receiving All Data but in parts of 20 bytes (i.e after receiving 20 bytes BLE_NUS_EVT_RX_DATA event is occures...
