Hello,
in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
Hi
The TWI driver has a twi_clear_bus() function but the TWIM does not.
I'm getting an I2C error, and need to do I2C soft reset. I'm doing this manually at moment but...
I recently completed a field-upgrade path from an nRF5 SDK 17.1 application (with the legacy Secure DFU bootloader) to a fresh NCS-based firmware stack, while preserving user...
Hi, I am trying to understand the Friend and LPN behaviour. For that I am refering to nRF sample application light" and "light_switch". Below is the setup details: 1. On one...
I tried to redefine weak app_error_fault_handler by custom one (nRF5 SDK for Thread and Zigbee v2.0.0, Segger Embedded Studio), according to https://infocenter.nordicsemi...
Hello, I am currently in the micro selection process for a project looking to go to production that requires the capturing of an image and the sending of that image over Bluetooth...
Small bug report: MAX and MIN are defined in param.h. nordic_common.h redefines these macros which creates warnings if param.h is also included. nordic_common.h should check...
Hi , everyone
i want nRF52840 to acts as central and peripheral simultaneously . how can i achieve this ? i have seen in website nRF52840 can concurrent upto 20 link (multilink...
Hi,
how to connect multiple peripheral to single central using app , i wan to send the data from central to multiple peripheral and peripheral will also want to send the...
Hi, I'm currently developping my first app in java.
This app requires a direct connection with my BL652, which doesn' t accept any kind of pairing option. That being said...
I'm migrating a project from SDK 14.2.0 to SDK 15.3.0. I use gcc. I have three advertising modes and the first of them is working fine. For the second one, the same
ble_advertising_init_t...
Hello,everyone
I want to add dfu service in UART example ,but when I tried to allocate the RAM,Debug terminal shows nothing,Then I set the breakpoint in nrf_sdh_ble.c and...
I am using Nordic SDK 15.3 and nRF52840 to interface to a NAND flash TC58CVG2S0HRAIG. I'm new with the SDK and I have little experience with the SPI / SPIM functions. I started...
Hi guys,
I use SDK14.2 (i can switch to SDK15.0 if it makes any differences) and would want to integrate FreeRTOS to my existing project. I have tried the FreeRTOS example...
Hello,
I need to measure battery on my nrf52 beacon. My input voltage is 4*AA batteries(each 1.2V so in total 4.8V). The schematic provided by the hardware developer is...
Hi
Am trying to implement the secure bootloader for the nrf52840 for Dongle,I have gone through the existing example for nrf52382 but am unable to find any example for nrf52840...
