Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hello,
I only want to know if it is possible to enable and configure the Server Name Indication (SNI) for DTLS on BSD sockets and CONFIG_NET_SOCKETS_OFFLOAD=y (not using...
Guys,
I am able to successfully build zephyr/samples/hci_usb for nRF52840 USB Dongle, but the same sample code fails while trying to build for nRF9160-DK
Works as expected...
Hi! I'm working on a mobile application that interacts with an NRF52 device. We'd like to be able to programmatically reset a device stuck in DFU mode so that it tries to...
Hi,
I have never used Nordic devices before so apologies if these questions are answered well somewhere, I just can't find the best article anywhere.
The project I am...
Hi, I have built a BLE-enabled sensor that is capable of measuring the air flow and volume passing through a pipe. A new sample is generated every 10 ms.
In the language...
Hi,
I am currently developing a project using ultrasonic sensor for measuring level. So I was migrating library from development kit to nrf sdk code. I am using Keil uVision...
I am trying to interface winbond flash with the 33 board using ncs and VS code , I am able to get the code to compile and not receiving any errors , it is working and no matter...
I'm trying to use `bt_hci_register_vnd_evt_cb' to register a call back to process vendor specific hci events.
below is my prj.conf
my callback function for testing...
Hello, Everyone. Now I am trying to develop a BLE mesh firmware using my customized nRF52832 board. I followed this tutorial https://youtu.be/ufjv2NaLfN8?t=1745 But I can...
Dear Community,
Why is the nRF Connec SDK is mixing up path separators '\'and '/' when building under MS Windows 10
with nRF Connect Desktop 3.12.0 / toolchain manager...
I've been following this blog post to increase BLE throughput for my application: Building a Bluetooth application on nRF Connect SDK - Part 3 Optimizing the connection -...
I'm using nRF5340 DK for BLE, AoD (Connection). I am also using the TX example from nordic. I can add extra antennas to the ant_patterns[] (up to 17), with no errors. I also...
Target nRF52832(nrf52dk_nrf52832) SDK NCS v2.0.0 I'm testing NCS 2.0 with Android 12. Making pairing with Android, I call two API when connected.
bt_set_bondable(true);...
Hi there,
I have a problem to implement the SPIM in the Network core. I cannot detect any signal from SPI_SCK & SPI_MOSI by oscilloscope and logic analyzer (no signal from...
