Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hi,
I am using version S140 of an nRF52840 in an application that creates an extended (S=8) advertising beacon. For my application to comply with regulations, I need to...
On iOS 18 beta we faced a random issue: creating CBCentralManager doesn't trigger BLE permission dialog. There is a thread about this on Apple forums .
Freshly installed...
Dear support team, I see that the mater/Template (Release) example only needs 715K of memory, as shown below:
I want to use nrf54l15pdk/nrf54l15/cpuapp to compile a firmware...
I am experiencing an issue to reach the ADC Max value(4200mV) on the nRF5340(our custom board) . We are using a 12-bit ADC, 4.2V and received a reading of 3297 mV, but we...
Well, this one took me many hours of tracing to track down the root cause, so I hope it helps someone!
Note: I wasn't able to reproduce this directly with a sample included...
I'm trying to debug on the Thingy:53 platform using an Nordic DK as the J-Link intermediate. However, with NCS 2.6.1, adding ` CONFIG_DEBUG=y` to the project configuration...
I am programming with the nRF52840DKs. [Toolchain Manager: v1.3.0, IDE: Visual Studio Code (VSCode), SDK: ncs v2.6.0, window11 pro]
I am currently working on integrating...
Hello,
I am using the nPM1300 in my hardware design along the nRF52840 and a battery from Renata (ICP622540PMT) . All the power outputs of the nPM1300 are in use (LDO1...
Hi! We are currently in the process of migrating our nrf5 SDK code to NCS, on nrf52833-based hardware. After being stuck for a while on the basic init process of MCUBoot,...
Hi everyone, I haven't found any discussions on this topic yet. I'm trying to flash my nRF52840 custom board, which I bought on AliExpress. It's named "nRF52840 SuperMini...
Hello ,
Is it possible to possible change/disable the BLE services at runtime in zephyr ?
For eg. we have services A,B and C in normal operation and we want disable...
I'm having 3 issues with I2C: A) It keeps returning -5 (-EIO), failed to write to I2C device..., however I do sometimes see the byte going out so I'm not sure why it always...
Hi, I'm working on nRF5340 Bluetooth LE peripheral (building environment: NCS 2.6.1, Zephyr 3.5.99). The net core is populated with the Zephyr HCI RPMsg sample LE Controller...
