Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
I connected to the cloud with the factory installed fimrware ( thingy91_1.4.0_production_final, mfw_nrf9160_1.1.1).
In the "Firmware Updta History" it shows: "To use the...
Hi,
I'm working on optimizing the download time of data via bluetooth with the nrf52820 android and IOS phones. To do this, I chose to play with the connection parameters...
Hi,
I am using a j-link EDU to program our devices. I use nRFConnect 3.11.0 and prorammer 2.3.3. My problem is that I don't get the j-link device up in the programmer tool...
Hello,
I am testing out a custom board with the nRF52840 and I am trying to interface with an I2C slave using the chip. Right now I am just trying to see if I can find the...
Hello,
I was not able to see the device in select device drop down box in nRFconnect programmer app. My aim is to program BLE soft device into the DK.
OS: Windows...
Dear Forum,
I have successfully compiled and pretested the direct test mode firmware for SDK_17.0.2.
The UART is shown as /dev/ttyUSB0 in my Ubuntu 20.4 Linux system....
I am attempting to write my own nRF5340 cpunet bootloader using nRF Connect.
This code is likely to be in a medical device; so, it is crtiical to be able to recover from...
Dear All, I would like to know if there is any limitation on the number of iBeacon devices that can be detected (scanned) from device. I assume the answer to that may depend...
Hi ~~
I can't use CLI(command line interface) to build code, but VS Code is workable.
CLI build log:
VS Code build log :
Error message (cut from CLI build log...
Hi Nordic,
I want to have a cli function over USB, I tried example under "samples/subsys/usb/cdc_acm", looks it can run but nothing show on console, anything I missed? Thanks...
For my application I'd like to have my device (nRF5340) be simultaneously (1) a central with a single peripheral connected, and (2) a peripheral with multiple centrals connected...
I am trying to Wearable (smart watch)
My board will have 3.7V lithium button cell directly connects to VDDH and I couldn't find examples for internal regulator as power...
