Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Can we use the nor flash on the nrf52833 soc ? currently we are keeping the DNP if we want in future i just want to know whether it will support from the firmware perspective...
Hi Team,
We require the detailed procedure for locking and unlocking JTAG access on the nRF9160 device . Specifically, we are looking for:
Steps to enable JTAG protection...
Enabling coded broadcast compilation may result in undefined coded parameters, and coded scanning may also generate errors. May I know which SDK version will support these...
In our product, we use Laird (Ezurio) BL653 BT module. In some countries such product requires SRRC certification. For SRRC certification we set BL653 to DTM mode with AT...
Environment:
Hardware: nRF5340DK
NCS version: 3.2.4
CONFIG_POSIX_TIMERS=y
CONFIG_POSIX_MONOTONIC_CLOCK is not set
Problem:
When calling clock_gettime...
Hi Team,
I just wanted to ask is amazon sidewalk support package for nRF54lm20b is available. If yes, please guide me with steps to add it to the project.
Thanks and...
Hello,
Is it possible to configure an nRF5340 to be both a Broadcast Sink and a Broadcast Source, but with the condition that only frames received by the Broadcast Sink...
Hi,
Any specific reason the errata Anomaly 166 : https://docs.nordicsemi.com/bundle/errata_nRF5340_Rev1/page/ERR/nRF5340/Rev1/latest/err_340.html resolution patch as present...
Hello, I have been testing a simple ble beacon code on my nrf7002dk. And when I connect the ppk2 to the device I see on average of 10 mA. When I plug the ppk2 to a nrf52840dk...
Hi,
while developing a custom driver for the nRF54L15, using the PWM I have found a potential bug.
I have removed the custom driver and just enabled PWM shell and I...
I'm using the PPK2 to develop a product with this device: https://wiki.seeedstudio.com/xiao_nrf52840&_wio_SX1262_kit_for_meshtastic/
Specifically, I am using the Digital...
Hi,
I am developing an application for the nRF54L15 using NCS v3.2.4 , running entirely in the Secure domain .
My goal is to maintain a continuous hardware system time...
The upcoming version of nrf_modem in nrfxlib (labelled v3.3.0-preview1 in the docs; sdk-nrfxlib git commit 6a51711ee4c4c3392a5da4f683e30901820f6b3f) has lost its define `NRF_MODEM_DECT_PHY_SHMEM_CTRL_SIZE...
