Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
I am trying to write to NRF_POWER->GPREGRET to store some variables that should be retained through a software reset.
I am running SD 5, SDK 14 and using GCC to compile...
I would like to write a program to communicate directly to the Dongle over USB. The plan is for manufacturing test fixtures to communicate with the 'device under test' over...
Hi all,
I want to disable SD and reinit SD and reinit my services.
I try by ble_app_uart example.
I add code for button, when I press button 1, it disable SD. When I...
Hi,
I just started working with Nordic chips so I apologize if I am missing something obvious here
I am using a custom board that I designed containing a nrf52832 module...
First of all, Because of my poor English, and I'm newbie this kind of work.
I'm not sure you can understand my question. But I'll try
Currently, To see my borad's log...
Hi everyone,
I am trying to implement my device with nus service. Both nus client and server role on the same device, similar to the official example of "relay".
But when...
Hi everyone,
I would like to build the Bluetooth network having three devices such that any two of them could communicate with each other. Is it possible to do it with nrf52832...
Hello,
I got Thingy:52-SDK-zip from https://www.nordicsemi.com/Software-and-Tools/Development-Kits/Nordic-Thingy-52/Download
and I did all setps wrote in README.md. Then...
Good day!
As base I used this examples:
ble_app_multiperipheral - for connection handling
ble_app_hids_keyboard - for whitelist and bonding
Error occurs after...
I am inquiring about the ability of the nRF9160, does the device have the resource to be a picocell? Specifically, can it handle communication to and from a single cell phone...
Hi
I‘m working with the SDK since many versions. One thing I don‘t understand is the sdk_config.h concept.
My first thought was that there is a master sdk_config.h in...
Hi, I made a PCB board nrf51822.
Because of my mistake, Rx, Tx pin was not cross connected to MCU.
So i want to change Rx <-> Tx pin.
In the example of ble_app_uart_s130_pca10028...
hi,everyone
when i test the mesh/example/dfu , it is upgrade scucessed,but when i combine it to switch_light example ,it was failed , it looks end the transfer too early...
Hi, there~
I'm trying to make my own bootloader and starting with the secure bootloader sample code.
The problem is the orignal bootloader, that is compiled with secure...
