Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi What is the best way to read cluster attributes periodically in zigbee network coordnicator? any sample code available for one time request or subscription for value change...
Hardware Setup:
nRF52840 DK: Serving as the BLE central device and I2S master.
PCM5102 DAC: Connected to the nRF52840 DK via I2S. The connections are:
LRCK (Pin 30...
Hi ,
For Battery operated devices, we are using NRF52840, and developing the firmware using Segger Embedded studio + NRF SDK. s140nrf52720, nRF5SDK1702d674dde
For our...
Hello,
I'm sorry to ask a maybe stupid question, but I'm a bit lost with the available boot loader options right now.
I want to setup an updatable and secure bootloader...
Hello,
I am using nRF9160DK, nRF SDK 2.8.0 with sysbuild and trying to enable image encryption trough sysbuild Kconfig options. I have set SB_CONFIG_BOOT_ENCRYPTION and...
Hi, After switching to a newer Zephyr version with the hardware model V2 I am struggling to build a BLE sample for the nrf5340 DK. It seems that the netcore image is not built...
Hi guys,
I'm working on a project with a custom board around nrf52832 chip and I'm trying to generate an 8MHz clock signal using the compatible "pwm-clock" on Zephyr.
...
Hi, I have encountered some problems:
hardware: nrf5340-dk
software:Visual Studio Code
ncs:2.5.0
sample: nrf\samples\bluetooth\direction_finding_central & direction_finding_peripheral...
SDK 2.1.0
nRF9160
Hi,
I recently configured a GPIO input in my project with an associated interrupt whenever it detects a high to low transition. The transition is...
Hi,
I am currently extending the NRF Cloud multi service sample, thus I am constantly reflashing my NRF9161DK during development. However today, my device fails to connect...
Hi,
While debugging an issue with reconnecting to our Azure server after the network is lost for some time, I found that azure_iot_hub_connect() returned a non-negative...
I tried to use `-Dmcuboot_DTC_OVERLAY_FILE` to use different mcuboot overlay for different builds but it always use all the overlay files in the folder.
The same way works...
This is a continuation of Case ID: 272157
That case resolved issues I had dynamically changing the device name (and having that new name show up in advertising).
It seemed...
I tested with an nRF52840 dongle, but it seems that nRF Connect for Desktop cannot scan long-range/coded PHY advertisements.
(I used this BLE long range peripheral demo...
