Hi Team,
Is it possible to implement the iOS application to track the iBeacon Component after closing the application(Background processing).
Please provide any example...
Hi Team,
To implement iBeacon what are the things to be take care at the peripheral side.
Whether the code for advertising the peripheral in "CoreBluetooth" and "CoreLocation...
Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
Dear Nordic Support Team,
we are planning to use the nRF9160 DK outside of our development department. E. g. we would like to provide the board, along with a certain user...
Hello!
We have an application with an nRF52832 connected through an UART to another MCU. We want to have the possibility to update the nRF FW, but as nrF52832 only has 1...
HI,
I am running the this usbweb example on my bl653dvk board, ( zephyr / samples / subsys / usb / webusb /) . I am able to build it and flash it also. According to this...
Greetings,
Are there any possible ways to know when the scanner and advertiser start?
We are now testing our system using NRF52840 DK. In our system, a master needs...
Hello!
I'm running into an issue where zephyr initialization fails on a custom nRF52840 board. The nRF Desktop application fails to startup. When debugging the nrf sample...
When calling bt_gatt_unsubscribe, the write callback function returns BT_ATT_ERR_UNLIKELY because internally bt_gatt_unsubscribe calls bt_gatt_cancel immediately after gatt_write_ccc...
Hello Nordic team,
* device : nrf52832
* SDK : nRF5 SDK 17.0.0
I have one nrf52832 peripheral device on which two different BLE services(let's say SVC1 and SVC2) are...
I cannot get my nRF Connect SDK to install correctly such that VS Code nRF Connect extension works. On the Quick Setup, it complains that the nRF Connect Toolchain is invalid...
Hi,
I'm trying to run the pc-ble-driver-py examples on a RockPi 4 ( https://wiki.radxa.com/Rockpi4 ). If I install pc-ble-driver-py directly and try to run the serial_port_enum...
Hello people
I have two custom boards with and without Low Frecuency Crystal. While I am debugging, both boards work ok, I can do advertise, scan and read accelerometer...
Hi,
I'm working through the QDEC using the nRF2840 evaluation board and I've run into some confusion.
I have trouble getting the ACC or ACCREAD registers to actually...
We received the nRF9160DK that included default firmware for the Asset Tracker v2. The default version appears to be an older version of the application.
We built the latest...
