Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
It used to work, but now it says "Connected" but the rest of the GUI never changes and the mouse just shows a busy spinner. Here's the log file:
0;13:45:18.9900 [MainThread...
Hi all!
My question is:
My own application is built based on the example "ble_app_template", and according to the nrf51 SDK - Examples - BLE Peripheral, this example...
Hi,
I am using ancs service to get some information of my iphone.
I use nRF51822 microcontroller and Nordic suggests to use the new SDK (5.2) for new microcontroller...
Hi,
I am using 2 esb devices to test my packet send and received.
My use case is:
1. Node-1 and Node-2 is power-in in PRX mode
2. Node-1 switch to PTX and send a packet...
Hello guys,
I am new in the BLE world.
I am currently using a BLE Android application running on a tablet + nrf52832 communication with another chip through UART.
I...
I understand only the flash memory that stores the boot image is available. We need ca 32 Kb of persistent storage. How can that flash memory also be used for additional persistent...
Hi, all
I'm using nRF52832 pca10040, s132.
I successfully read peripheral characteristic using 'ble_app_uart_c' example.
However, I read once only when the connection...
Hi,
I am struggling to find out why my device will not immediately start my application after an OTA DFU upgrade.
I am using buttonless DFU on a custom nrf51822 board...
HELLO,All: When using SDK5 From 52840 change to 52833 ,There are some errors,as below: 1.Output/Release/Exe/ble_app_hids_mouse_pca10056_s140.elf section `.init' will not fit...
Hi:All:
A: Since I have getten help to make left/right button working well, but I just want to know the dataflow from the button being pressed to released. 1. It means that...
Hi,All:
When i use SDK16 ble_app_hids_mouse example, the computer warns: driver error.But when i use the same dongle with another mouse,it is no problem.It seems the problem...
