Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
We built a prototype board using the nrf52840 QIAA package, then developed a production board using the CKAA package. For some reason the Zephyr system tick is about 5x slower...
Hello, I try to transplant some code of project \examples\dfu\secure_bootloader\pca10056_uart to project \examples\dfu\secure_bootloader\pca10056_s140_ble. Trying to make...
Dear Nordic devzone community,
I am using nrf connect SDK version 1.8.0 for the asset tracker and 2.0.2 for AT client. IDE is Vscode Studio.
I have designed a custom board...
Hello,
I am working on a demo for multiple audio sources (using 1 nRF5340 Audio DK per audio source) connected to a central (which will be an nRF5340 Audio DK). Is there...
Hi,
In my project, I have to connect to a ZigBee Hub provided by a third party, and the problem that I am encountering is that I am unable to rejoin to the network after...
Hi, greetings all !!
I am developing an application based on ble_uart_peripheral example on nrf52dk_nrf52832 using NRF Connect SDK2.1. In my application, I have to receive...
Using Ubuntu (same behavior on 20.04, 22.04, and 22.10) and nRF Connect for Desktop 3.12.0. I have my J-Link hooked up to an nRF9160 on a custom board. When I check it at...
Hi,
I want to build this sample https://developer.nordicsemi.com/nRF_Connect_SDK/doc/2.1.2/nrf/samples/nrf5340/multiprotocol_rpmsg/README.html as a multi image build with...
Hello,
our Team is thinking about using the %XPRODDONE AT comand for the production devices, but we are not sure about all consequences of doing this.
The Documentation...
Hi Nordic team
Developing a nRF5340 hardware I need to add a debug connector. I use segger j-link and this cable
I tried to find out about the pinout/connection to the...
We have recently acquired a few BL651 modules from LAIRD which are based on nRf52810. Currently we do not have any development kit but would be getting one soon. Using The...
This is my first design with a BT product so apologies if my quest is a little simple.
The advice I was initially given was just to cop the dev board design and it “should...
Good day
I am trying to run the l2M2M_client sample on the nrf9160dk and have just downloaded the latest toolchain. I have gotten this error, while building, before even...
