Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hi, I wantto use this example https://wiki.makerdiary.com/nrf52840-m2-devkit/python/examples/lcd/ with my nrf52840dk . how to use this with nrf52840dk? .I have st7789v display...
Hello,
We have a custom board with nrf5340 (we are using ncs2.6.0). We are using CPUAPP, CPUNET, and MCUBoot. When we use the Nordic nrf5340 devkit, it works fine and when...
Hello,
I'm implementing the Nordic firmware upgrade using FirmwareUpgradeManager from the Android SDK ( https://github.com/NordicSemiconductor/Android-nRF-Connect-Device...
Dear Nordic support service,
I am currently using nRF21540 with nRF52840 and nRF5_SDK_17.1.0.
I am able to transmit and receive, but I am not able to switch from RX to...
Dear Nordic Semiconductor Support Team,
I’m encountering two related issues when updating my nRF9160 application firmware that cause the Onomondo SoftSIM profile to be erased...
The attachment "peripheral_uart_1_timer20.zip" is the project engineering file. Actual tests show that timer20 is not as accurate as Ktimer.
Another strange thing is...
Hi
I want to know if I send a data from peripheral, how many time the central device could receive. Some people said that I could use the sniffer to caputure the interval...
How to check CS procudure used by controller in BLE Channel sounding security I am refering to this ticket so i have questions related to it that
I have tried to find answers...
I have three 5340 Audio DKs (PCA10121) and I am trying to demonstrate one as the broadcaster and the other two as headsets with audio transferred between them but NRFconnect...
Hello,
I’m working with the nRF5340-DK using nRF Connect SDK v3.0 and the SoftDevice Controller. My goal is to support multiple simultaneous connections , and I have already...
The Errata 155 workaround seems to work for the nRF52840, but only when events are configured before tasks. If I configure a task for an unused output pin *before* configuring...
Hello, I want to use the nRF52820 as a slave device. I've left my code, prj.conf, and DTS files below, but the spi_transceive function seems to be getting stuck. What could...
Hi,
I'm using the nRF52840 with the SoftDevice for BLE. In my system, it's primarily a BLE transceiver controlled via SPI by an external TI MSP430. We're considering implementing...
nRF54L15 LE Audio with I2S interface, LC3 codec point-to-point audio The specific flow is as follows: The nRF54L15 communicates with the mic via I2S to capture audio data...
