Hi,
I'm starting to implement DFU using IAR's ARM workbench. In the example project for ARM that comes with the nrf51_sdk_v5_2_0_39364 SDK there is a file called bootloader_util_arm...
Do I have to use external host MCU for nRF51422? What can the ARM Cortex processor inside SoC 51422 do and cannot do?
I want to create a mesh network with hundreds of ANT...
Hi
I am looking at section 9.1 of the S110 Softdevice Specification v1.3A and the release notes for 7.0.0-2.alpha where I see that an application now starts at 0x15000...
Hi
S110 v7.0.0-2.alpha got released today.
In the release notes it says...
[b]The SoftDevice can now be configured to forward interrupts to one of several applications...
Hi,
I use the nrf51422 chip.I want to know if the ANT establish link between chips,where can I get the matching configuration (like device type、channel ID).I mean is...
Is there a way to recieve more than one write callback for a given characteristic, per radio session? It seems like I can rx 1 time per attribute per radio session and tx...
I was pairing using nRF connect app via mobile phone and I noticed that there's a check mark which says "PIN contains letters or symbols":
Is there a pairing method which...
Dear,
I want to use the nPM1300 in my design for general Power Management.
I also want to use a Load Switch to disable some components in my design, but I do need to verify...
Hello,
I'm developing a firmware based on Zigbee CLI sample and enabled DFU of app core and net core via serial.
Now I am setting a custom key for image signing and...
Hi, i've been trying to use gnss function indoors and therefore i need to install an external antenna on my nrf9160dk.
I've read the requirements but i'd like some professional...
i need information on power consumption during advertising and connection in my case its taking too much high current around 1 ma in advertising and 1.5 ma during connection...
I want to implement Buttonless DFU for nrf52833 but unable to get how to implement it. I have gone through some links but that seems to be unclear. How can I implement the...
Hello guys,
I tried to design a pcb antenna for a nrf24l01+, since my company doesnt allow to buy cheap smd breakout board version from china anymore
The pcb stats of...
Hi,
Is there any way to run calibration of the LFCLK at the same time as the RTC is running on the same clock?
At program startup I start the HFCLK, then run this routine...
Hello, I’m developing application for nRF9160 with Zephyr RTOS. Currently I want to add a task watchdog module with a hardware watchdog fallback. I use three threads which...
We created the transceiver side and receiver side sources by reusing the nRF5340 Audio source.
I am creating it in CIS mode using VSCode.
The build ends on the receiver...
Hello,
I am working on a project were two MCU's need to communicate with each other via UART. I am using async UART. I am stuck with this problem where after
PM_DEVICE_ACTION_RESUME...
I'm currently working on a firmware for a device where the app core and net core need to share some sensor and configuration data. I want to use the rpmsg_service for that...
Hi Nordic Community,
I'm currently working on FCC certification for a project and need to enable BLE Direct Test Mode (DTM). I'm using the `hci_uart` sample and have activated...
