Hello,
How many RX buffers are in S110 SoftDevice? I know there are 6 TX buffers (so you can send 6 packets per Connection Interval).
How is it on receiving?
Is it e...
My sensor is off-standard,so I have to use gpio to read and write my sensor.
Gpio IIC will take about 0.5ms to get data.
My app need send data every 7.5ms,it seems that...
Hi,
My android Proximity application fails on service discovery only for the very first time it connects with the devices(nrf51822 evaluation kit with sdk 5.2.0). Actually...
Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi!
The posts I've found regarding this were quite old, and they mentioned features which then were coming.
So I'll ask anew: Is it possible to use AT-commands through...
Hello,
I would like to ask you if SoftDevice S132 v.7.x.x allows Master-initiated Feature Exchange procedure?
BLE Core spec: Vol6, Part B, Cap. 5.1.4.1.
I tried to find...
Hi everyone, I use nrf52833 to make dongle. My test found that after suspend of usb, I tried to enable ESB rx mode, but I couldn't receive rf data. What is the problem?The...
Hello,
When deleting a bond from the central, after trying to reconnect with the peripheral the PM_EVT_CONN_SEC_CONFIG_REQ gets called as expected. I know that allow repairing...
I have been trying to develop a project, my custom board has a nRF52840 chip and I have a nRF52840 DK too.
My problem is when I try to debug any example from any SDK....
Hi, I attended the Nordic Seminar in Tel Aviv last week and heard several lectures from your experts.
It was recommended that we use a module with Nordic IC rather than...
Hi,
I am using vscode and nCS on windows, kindly help me with below 3 queries:
1. How to generate a binary signing key, say "KEY_1"..?
2. How to sign a binary with...
Hi,
We are trying to use PPK2 to measure current of our board, we want to receive the data from PPK2 and parse by our owner python script, so could you provide the protocol...
Reading The adhoc smart waste solution uses the nRF9160 SiP I tried to reproduce the mention 6 µA with LTE-M in eDRX with an interval of 655 s.
I use
CONFIG_LTE_EDRX_REQ_VALUE_LTE_M...
Hi,
We use PPK2 very conveniently as a logger for testing.
How about adding the supply voltage as display options also?
We hope you will consider this.
Thank you...
Hi dear,
It is possible to establish parallels multi connection to different J-LINK's devices serial numbers via nrfjprog.dll, or any other automated way ?
We successfully...
Hello, I'm making a breakout board with nrf52832 qfaa. I used chip antenna (2450AT18B100E) and followed Nordic reference layout. I am getting around 60m range in an open environment...
run nrf Connect for bluetooth Low Energy Standalone
connect PCA10040 board
select "server setup"
press "+ New service" which adds a New Service
press "> New Service...
Hi, I am currently learning to retrieve location using thingy 91 and location example from nrf SDK. When I run it, I got this message (below).
After doing some research...
