I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
Hi, i'm trying to modify the thread coap_server sample by adding bluetooth configurationg following this webinar https://www.youtube.com/watch?v=hY_tDext6zA&t=2199s
I'm...
Hello,
I'm working with the nRF Connect SDK version 1.8, using Zephyr and a CC1101 radio module. The radio communicates via SPI, but at the beginning of the process, I need...
Hi
which function do I need to call in a peripheral to stop advertising?
Where Do I find the documentation for it?
which function do I need to disconnect ?
Where Do...
My company has been assigned a 16bit Service UUID from Bluetooth SIG, which we wish to use in advertising with the Service Data AD type.
However as soon as I swap our binary...
Hello, I was wondering if somebody has an explanation (or has seen the same problem) for the following event:
We have had 5 units with NRF9160-B0 in the field for testing...
Hello, On my nRF9160 custom device, I have enabled XPOFWARN to automatically switch off the modem in case the voltage gets too low. It's working fine. This case happens when...
Hello Engineer Greetings Of the Day We performed DFU over BLE with secondary slot in External flash that operates using SPI . I needed some clarification on the outcomes ...
We have a custom board with nrf5340 and we use SDK v2.5.3 for software development. Our BLE signal strength seems too weak with the default TX Power setting. So we would like...
Dear Team,
May I know how to install Nordic Edition of SEGGER Embedded Studio?
I did not see any executable file after downloading.
I ma onlz seeing the below files...
When building the Matter weather station sample, without any changes, I see many warnings regarding incorrect project configuration, such as conflicting options or missing...
I attached an external nRF52840 to the debug out port of the nRF 7002 DK (as seen here ), but cannot get a connection to the external uC.
I know the cable and uC work...
Hello Nordic community,
I’m working on a project that primarily uses GPIO for controlling locks, Bluetooth communication, and is powered by a battery. I’ve attached the...
Hello，
I am using a customized NRF52832 circuit board. During the Bluetooth connection test with a mobile phone, the connection suddenly disconnected, and then quickly reconnected...
