I want to count clocks in order to implement a watch. I use the RTC0 as my time-base and count mainly with this device. As it has just 24 bits it would not last for long,...
Hi,
how long does it take time if i would wake up a nrf51422 rev2 (ANT and BLE) in deepest possible sleep mode ?
And how long does it tai if after wakeup it had to communicate...
I saw that the app_timer uses the SWI0. Could you explain what it does and what the advantage is compared to "timer_list_handler_sched()" calling "timer_list_handler()" directly...
Hi, I used the sample code "Master Emulator->2.1.7.8226->Example code->nRFUart"
to develop a new project, and encounter some questions...
we update nRF6310...
Hello,
How many RX buffers are in S110 SoftDevice? I know there are 6 TX buffers (so you can send 6 packets per Connection Interval).
How is it on receiving?
Is it e...
My sensor is off-standard,so I have to use gpio to read and write my sensor.
Gpio IIC will take about 0.5ms to get data.
My app need send data every 7.5ms,it seems that...
Hi,
My android Proximity application fails on service discovery only for the very first time it connects with the devices(nrf51822 evaluation kit with sdk 5.2.0). Actually...
Hello,
First of all, I'm not a hw-engineer
I've 2 evaluation devices of nRF52840 (BL654-DVK) and I'm trying to test the SPI communication between them (one as master ...
I have successfully run, Nordic serialisation connectivity application on nrf52480, (And able to control this from a custom board, and also from PC). But I want to use a lighter...
Hello !
I'm currently working on a project using the DK Boards nRF52832 .
I'm disappointed that one card no longer works ( doesn't light up ). I therefore explain to you...
Hello everyone :)
I'm trying to get an analog signal from n channels. I started with modifying the battery sample from Vdd to AIN0 according to the modification - only to...
I am using Nordic Serialisation library, with a nrf52480 chip as connectivity chip and a m4 arm core custom board as Application chip. I am able to establish gap connection...
Hi,
I am trying to enable the internal clock for NRF 52832 (BMD-350) module.
The configuration option for the clock has
1. RC Oscillator
2. Crystal Oscillator
3...
Hello,
I am using the nRF52840 DK to debug my application using nRF Connect SDK v2.0.0 ..
Application runs well in debug.
But when click restart / reset .. it should...
Hi Team,
I am working on NRF52832 based on the BLE mesh protocol here I am using the Light_switch example of SDK - nrf5sdkformeshv500sr
Here I transfer boolean(0 and...
Hi, I'm developing an application based on ble_app_uart, and integrate FOTA is the last feature. I'm using sdk16, S140, nRF52833. I plan update firmware over BLE, so I have...
We've a custom board which has NRF52833 and TM52F1376-MTP-C3. They are connected over UART.
What I want is transfer binary data between Phone and nRF52 over BLE.
and then...
Hi Nordic team,
I'm going to start new BLE application project, so I tried to understand how to use nRF52 series first.
I completed the academy and I'm trying to make...
I am attempting to compile the peripheral_uart example targeting nrf52840dk, I've done quite a bit of work with zephyr but never with the nRF Connect SDK. I've encountered...
