Has anyone converted the app note AN34 DTM Python script to C# or C/C++ ?
The Python DTM script is works OK with the setup specified in the app note AN34 figure 2, which...
Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hello!
Running Windows 10, nRF Connect for Desktop v3.7.0, Bluetooth Low Energy v2.5.2.
Have the following section added to the uuid_definitions.json:
The problem...
I am sending data over air from an XBee in transparent mode to an nRF52840 dongle as ZC.
The data is going over the air from the source and destination addresses using a...
Current status. Bond is required to perform FW updates while in OTA mode.
What we want: No Bond is required for FW update in OTA mode, FW files can be uploaded unilaterally...
Hi,
I have questions about the connections between the nRF5340 and the FEM nRF21540.
The nRF5340 has these components:
And the nRF21540 has this component:
I wonder...
Hi everyone,
I am currently reading the nRF53 Series product specification from the info center for evaluation purposes. During reading and looking at the application...
Hello.
Please forgive me for a real beginners question but I would like to understand the relation between the menu configurations in SES and the different configuration...
During a FW update, it failed for some reason and then I couldn't get anything to work. I can't come back from OTA mode. Reset does not work either.
According to the log...
I just found out there is no SPI slave support for SPI3 on NRF52840, but the memory map shows a SPI master for SPI3 though. Is it possible to enable SPI slave on SPI3? We...
Hi,
1. I have implement DFU example without private key (open bootloader !) . How to implement secure bootloader for NCS .
2. when i use the DFU with hid_keyboard the...
Hi! Writing to flash memory. After calling nrf_fstorage_erase (...) a hardfault happens. It only NOT happens if JLink is enabled (using dbg or rtt logs). So I can not debug...
Hi i just bough module E73-TBB(nRF52832) from EBYTE . I've already downloaded the sdk this link https://www.nordicsemi.com/Products/nRF52832/Download#infotabs
I test with...
Hi,
I would like to set up RTT on both net and app cores, but I haven't been able to get both running simultaneously. I'm wondering if this is even possible, and if so...
