Hi, For my project, I need to design a BLE packet sniffer which scanning the 40 channels. Therefore, I need 40 dongles are connected to a computer that can read and transfer...
I am writing code to get a nrf52840 DK to associate with an existing 802.15.4 coordinator using the 802.15.4 API module within SDK 15.2.
I've called "mlme_scan_req" and...
Currently, I am able to use Mqtt Publisher or Subscriber with only one Nrf52 device. I can ping to the device with link-local address.
I am using Nrf52832 with SoftDevice...
Hi everyone,
After days of figuring out how CMake works, I try to write a CMakeList.txt myself, and decide to put my progress on this community. Right now, using CLion with...
i am using nrf 52832, i got SAADC example code from sdk. that code done by using timer. i could not understand timer section. Is available SAADC simple example code without...
Hello everyone,
as indicated by this question https://devzone.nordicsemi.com/f/nordic-q-a/35692/adding-nrf52-dk-to-github-mesh-demo-for-thingys/138327#138327 I am trying...
As part of a university project I am trying to read an analog signal and transmit it at the maximum data rate over ESB. But I cant seem to get above 1700kbps without any of...
Hi Nordic team,
We are designing a custom board using an nRF54L15 together with an nRF7002 WLCSP.
Our board has a single 3.3 V power rail. We would like to confirm the...
Hi all,
Can anyone guide me to the right path where I can get how to interface an E INK DISPLAY(ET014TT1) to the NRF52840 DK board or tobwhere I can get the necessary steps...
I'm having strange behaviour after switching to 3.4.0 on nrf9151. Our existing application was working well on 3.2.0 but showed no life with 3.4.0.
To demonstrate, I built...
Hello,
I am having trouble programming the nrf5340 chip using SWD.
Set up:
Custom hardware with the MDBT53V-1M module from Raytac, nrf5340 chip.
SWD, using J-Link...
The nRF7002 Evaluation Kit and the PCA10143 Development Kit both show multiple vias to the ground tab pin 49 but there is no direct connection from the tab to pins 27, 28...
I want to use P2.00,p2.02,P2.04, P2.0 for UARTE20 on NRF5415DK.
This is to use the uart as an interface for HCI uart with NRF54 as the BLE controlller.
How to enable the...
I am setting up our production facility in India. Brought out our test jig software that flashes the nRF53 modules.
I use nrfutil to program the boards via "nrfutil device...
I am using the Thingy91X kit, and I am trying to make a sample 'hello_main" to work on the nrf5340. My project configuration is as follows:
Sample: zephyr/samples/hello_world...
Dear Experts,
We are bringing up a custom nRF54LS05B module and have built a small production-test firmware on top of the `radio_test` sample. While characterising current...
