There is the board mark on the chip like n51822CEAAD01350A0, where DO is Build code, 1350 is tracking code(YYMM), A0 is lot code.
My question is how can I get those codes...
I'm trying to debug a randomly occuring Hardfault. In trying to trace down the source I read the CPU registers use the Nordic hardfault_implementation.c which grabs the register...
Dear nordic employee
my purpose is send a data the length is from 150 to 273
when my server device send data by sd_ble_gatts_hvx（the send length is fixed 10 bytes） ...
Dear nordic employee：
The service I want to find is the sound service of the thing52 thingy sound service
I tried to modify the HRT_central_client project to find the...
When I was using the device as peripheral, I was wondering when the Softdevice notified BLE_GAP_EVT_SEC_PARAMS_REQUEST and BLE_EVT_SEC_INFO_REQUEST:
1, when peripheral...
hi dear nordic employee:
I tried to build the project ble_app_hrs_c（pca10040） by keil5
but I get an error :
._build\nrf52832_xxaa.sct(7): error: L6236E: No section...
Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
I changed Kconfig of u-blox board template and something is going wrong in create_nordic_project.py when I tried to create project in Segger Embedded Studio from changed template...
hi support team,
there is one question feedback from customer, device（832）is sending data to mobile device, however this connection is disconnected （however there would...
Hello,
very early evaluation question, the 52832 has NFC-A. Is a mobile phone capable of reading from this device (some arbitrary user data) ? Now I've started looking into...
Dear,
- nRF connect SDK 1.9.1
- nRF5340 DK
We use 5340 spi to control an adc chip. The sample rate we need is 1kHz, so we use k_timer to produce a 1ms timer.
However...
The issue is as stated in the title. The 'Select Device' column says "Connect a Nordic development kit to your computer" when the Power Profiler is NOT plugged in. This imediately...
Can someone help me with a Zephyr compiled blinky hex file please?
My Hardware is a loose standing module setup similar to NRF52833 DK. (same led_0)
NRF5 Sdk hex file...
I am using fstorage to store some data at three location in flash.
but it is hanging at wait_for_flash_ready function when mobile phone is connected through BLE.
Please...
Hi everyone, I am quite newbee to nRF5340 and nRF ecosystem. Anyway, my goal is to talk with 3rd party application to receive positioning data over bluetooth and then I have...
Working with nRF52840 and nRF Connect SDK v2.1.0., whenever I enable MCUboot in the project configuration, the reset pin gets enabled on the next flash. I believe this has...
Hi,
I encounter a problem, in my opinion, related to the modem firmware (or model B0 and B1).
My program connects to the LTE-M network and sends data from a sensor.
...
Hi all.
I'm working on a Visual Studio project, written in C++, which I'd like to import into Segger Embeeded Studio.
I've done this before successfully, but this time...
hi support team,
customer reported one problem that when 5340 spi communication is done, the clock line is much longer than cs pin as below:
number2 is clock pin, and...
Hi,
In the example "nrf52832 light_switch_server" ,Does it have the function interface for the friendship node adervertise to all lpn nodes at one time?
hope your reply...
