hello
i am using the Nrf52dk with Visualgdb.
i try to run the example project (tcp/IP -> client).
i am using the Nrf5 IoT sdk v0.9
Project complied successfully but i...
I'm using an nRF52 (SDK11.0.0, s132) and am able to generate a hex and axf via Keil/uVision. It uploads and works just fine using a Segger J-Link. I want to try some lower...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
HI:
i hava a sender and it send a frame every 15ms ,not use any protocol,and reciver code like as follow:
while (1) {
Rf_StartRx(ReciverSC.RfBufPointer...
Hi to everyone,
i have an mb39c811-evsk-02 and over it there is a tmp102 temperature sensor and an nrf51822.
I want to read the values of the sensor over a beacon app. ...
Hi Nordic,
I have got an nRF52833 DK PCA10100. In SDK17.1.0, there are few examples about nRF52833, for example, what should I do if I want to use examples\ble_central\ble_app_multilink_central...
Hello,
I attached LIS2DS12 accelerometer sensor driver to the nrf5340 board, and I am trying to do (1) i2c access and (2) single tap interrupt handling (the sensor activates...
Are there any samples that show how to use the nRF PPI subsystem with nRF Connect?
My task is to configure the SAADC to take samples at 200hz, collect the samples into BLE...
Hello to the community!
I have two nRF52832 sensor nodes and aim to implement synchronized sampling of all sensors, including synchronization between sensors of the two...
Hello,
I've implemented DFU OTA updates and it works using the nRF Connect app. If I wanted to do this from a custom app from my phone, how would I approach it?
I've...
Hello,
I'm using the nRF Connect SDK v1.9.0 and a nRF5340 on a custom board.
I want to use MCUBoot as a primary bootloader. On the development kit, the UART connecting...
We have updated our firmware runnung on an nRF9160 from SDK 1.9 to SDK 2.1 using the now deprecated SPM (We will upgrade to TFM soon).
When booting our firmware, we initialize...
I've disassembled sd_app_evt_wait() in SoftDevice S140 v7.0.1 and clearly see that inside a loop, it calls WFE -> SEV -> WFE. (It also manipulates the MWU and looks at interrupts...
My board nRF52840-DK always take several minutes to be ready after plugging usb cable in. The issue like Markus described in this ticket:
https://devzone.nordicsemi.com...
Hello !
I can see nrfutil is written in python and have a lot of dependencies and functionalities what typically need for x86 based host.
A lot of discussions about porting...
Hi everyone.
I would like to know if there is any good nrf mesh communication libraries for desktop applications (preferably C#)?
I would like to develop some desktop...
Hi experts,
I have a problem with programming NRF5340 SoC when using the NRF-Programmer tool. About our board, we use PCBA instead of NRF5340 Dev-Kit.
Step1: My coworker...
I'm moving an application from NCS v2.0.2 to NCS v2.1.0
Everything compiles properly in v2.0.2.
I think I've converted all of the pin definitions properly from the v2...
