Currently we are considering whether we should use external Flash Memory or NRF52 Internal Flash.
External Flash memory has a lot of drawback in comparsion with internal...
Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
Dear Developer Zone,
I am new to ANT and am looking for someone to help me to setup an example 15 channel (14 devices) ANT network using the S332 soft-device to test communication...
Hello,
i am working with the Enhanced ShockBurst proprietary protocol and i am wondering where I can find the sources of this protocol, so that I can do some changes. ...
I have received a newer DK board (2.1.0) and have a problem.
The newer board wants to update the FW constantly when I run a test. That appears to be resolved by disabling...
As we know 52840 supports Thread,Zigbee and bluetooth,Do we need to test all of them in production test?
I'm not sure whether these 3 protocols are only software ,or they...
hi
1. #define ADC_NUM_CHANNELS DT_PROP_LEN(DT_PATH(zephyr_user), io_channels) this is example code from v1.8.0\zephyr\samples\drivers\dac\src\main.c but this is not working...
Hi.
We're using the out-of-the-box NCS 1.6.1 SDK / Zephyr / MCU boot process for our application. After upgrading the firmware, either via a dfu-utils flash to slot 1, or...
Hi everyone,
I've been trying to figure out what is the maximal BLE throughput between nRF52840 DK and nRF Connect (on iOS).
Using " ATT_MTU Throughput Example" between...
I have been trying to understand how we can use the PPI system to bypass extra callback handlers and threads in Zephyr to retrieve data from external SPI device based on external...
Is there a way to perform bluetooth operations using bluetoothctl The required functionality is: --- The dongle is plugged into the Raspberry Pi usb --- The dongle can then...
Hello,
I am running an ble_app_uart example from SDK 17.1.0 in SES on my nRF52-DK.
As great example as it is, I find it a bit non-practical for further development so...
I need repetitive Timer and Edge Counter in my application. There is is a single Timer Peripheral that can be used either as a Timer or Counter. As well, further in counter...
I am developing an NRF52833 application that reads from the I2C sensor MLX90641. Below is the code I am using to test. MLX90641_I2C_Driver.c was originally written for Mbed...
Dears
Th case ID of my old question is 218372.
I were waiting for two weeks. However, nobody responded to me.
I wanted to make a BLE mesh product used NRF52840 and NRF21540...
