void in_pin_handler (nrf_drv_gpiote_pin_t pin, nrf_gpiote_polarity_t action)
{
nrf_drv_gpiote_out_toggle(PIN_OUT);
}
This function work with interupt event (push...
here I have a very strange problem. I m trying to send the data(1 byte) from slave to master,and I have to use the multilink demo because I will have 2 slave devices.
The...
I'd like to erase all the pages managed by FDS as part of a "Hard Reset" operation. fds.c has a hint of a "FRESH_INSTALL" directive (part of an enum defined in fds_internal_defs...
nrf51822
SDK v10
SD S110 v8
hello!
My pj is about ANCS+nus+hid mouse sevices.
If my borad had bonded with an iPhone,then download new hex from mdk ,and run.
...
Hello.
I would like to develop FW for the nRF52832, using Eclipse IDE + ARM GCC + Segger JLink OB.
I've seen on the segger webpage that the nRF52832 is a Cortex M4 processor...
When using app_timer through scheduler, a break and go will overflow the event queue if a timer is a repeat timer. The effect is that it's not possible to debug.
To work...
I need to be able to actively set the value being incremented in the Timer2 register on the nrf52 (what I believe would be it's main register). It seems that this might be...
Hi,
I´m using SDK v16 on a custom board and try to implement the wake up functionality of the low power comparator. In order to describe the system as clearly as possible...
Hello.
I am programming the NRF52810 breakout board.
Before I am testing the prototype, I am using NRF52832 breakout board, and it works well now.
However, the same...
Hi Dev Team,
I was working with the nRF9160 and started off with the basic UART sample found here : https://github.com/Rallare/fw-nrfconnect-nrf/tree/nrf9160_samples/samples...
Dear every body,
some days before, i raise an issue relate my fault at here: https://devzone.nordicsemi.com/f/nordic-q-a/68010/nrf52810-issue-with-32mhz-external-clock ...
Hello
I'd like to reset using the firmware instead of the reset button on the board, is it possible? I'd like to reset the entire Bluetooth connection when it's disconnected...
HI，ALL：
Now, I am study frequency hopping.I found something might be different. It is more hard from highest frequency to lowest frequency(the same as lowest frequency to...
Hello
I use nrf52832 and SDK v17. I am programming BLE using UART service. So far, there has been no problem with testing with one phone, but if I disconnect the Bluetooth...
Hi, all
I'm using nRF52832 pca10040, s132.
Like 'ble_app_hrs' example, I changed the 'ble_app_uart' example to send data using app_timer.
In the example of 'hrs...
Hello,
I wonder if I can disable saadc interrupt because saadc is under control of ppi in my project and I don't even need saadc interrupt or interrupt handler.
As I know...
hello Nordic
i am working with nrf52832, sdk 16.0, s132v7.0.1
the device is suppose to be powered on by a press button that is held for a few seconds. there are 2 lines...
I'm trying to use the duration advertising parameter to have the advertising timeout. The timeout works as expected when I have the J-Link debugger attached, however when...
I have developed a custom Buttonless DFU application on top of the default example in the NRF SDK. In this custom app, I have also merged the BLE UART application, so I include...
