Ok so here is the issue. I was trying to build a simple application which is described in the tutorial for characters. After building an advertisement and understanding the...
I was working with IAR and SDK10.0 before. For some reason I have to transfer my project to Keil and SDK9.0. My program worked well for the old settings. While keeps got NRF_ERROR_SOC_NVIC_INTERRUPT_NOT_AVAILABLE...
Currently we are considering whether we should use external Flash Memory or NRF52 Internal Flash.
External Flash memory has a lot of drawback in comparsion with internal...
Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
We have an nRF52840 setup as a slave to communicate with a motor controller. I connected a logic analyzer to the lines to confirm the data being sent across. There are 18...
I am testing several phones with a specific App that I connect to my nRF52832. Some phones pair nicely but others do not pair as expected. They display two pairing requests...
I am looking for some sample code, showing how to send cloud -to- device messages to a device from an Azure IoT hub using topic direct method requests $iothub/methods/POST...
Hi,
I am working with the nordic thingy91 on a windows PC, and am noticing unstability regarding the USB serial port. That is:
- After a while, there is no data coming...
I refer to this guide to add dfu to peripheral_uart. The program runs on nRF52840DK.
1、prj.conf
I added the following macros.
CONFIG_MCUMGR=y CONFIG_MCUMGR_CMD_OS_MGMT...
For reading ecg data must synchronize GPIOE interrupt every 4ms,i want to creat a hardware timer with period 4ms, in this timer cb, take semophere gived by GPIOE interrupt...
Hi team,
I want to make simple communication between NRF52840 dongle and mcp2517 CAN FD contoller using SPI. I do not understand, how to send and read values to and from...
The initialized struct "nrf_fstorage_t" for use in nrf_fstorage_init( ) temporarily includes the application and bootloader (just for this test)
start address is 0x2'600...
Hi,
I have setup a provisionner with the sdk example that can provision devices. For that the provisioner scan unprovisioned devices and can start a provisioning process...
Hello,
I am trying to see how the signal strength for Zigbee and BLE changes when the distance between two nR5340 DK increases.
I used central_uart and peripheral_uart...
Although my Googling skills are not the best I have, so far, been unable to find any examples or driver documentation for the comparator peripheral of the nRF52840 for the...
I'm using the asset_tracker app on a custom board and have built 50 of the custom boards. All but one of them start the modem and listen to the LTE receiver for a full minute...
