Dear Nordic,
Do we have ready-to-use keyboard driver with scanning/debouncing?
I've not found an example or docs about using KSCAN with gpio-connected keyboard...
Dear Nordic Experts, This one's a tough nut to crack:
The firmware is based on nRF5 SDK for Mesh 5.0.0 with nRF5 SDK 17.0.2 and Softdevice s132 7.3.0. It runs on a nRF52832...
SoC: nRF5340 SDK: nRF Connect SDK 1.9.1
CMAC calculation works fine with SDK 1.7 and SDK 1.8. But it failed with SDK 1.9.1.
psa_mac_sign_setup returns error = PSA_ERROR_NOT_PERMITTED...
Hi, I'm pretty new to microcontroller programming so please correct my wrongs.
I'm using the Libuarte driver library to have the pca10040 talk to my server via serial connection...
Hello.I'm presently working in door sensor project in nrf52840.To use low power mode in sensor,I need some details,documents or SDK's regarding power management for further...
Hi All:
Now we are delveloping BLE Mesh using nrf52840 sdk( v5.0.0) and use light_switch example.
It is important for us to send 10 bytes of message from nrf mesh app...
Hi, all
I'm using I'm using nRF52840, s140.. pca10056.
I added a spi to the ble_app_uart example.
However, the handler is not called after the nrf_drv_spi_transfer...
Hello, I am trying to make a sinusoidal by using the PWM module with an interrupt handler.
The thing is, the signal looked perfect from the development kit. However, when...
Hi there. I've designed a PCB around the NRF52833-QDAA, mostly following the variation 2 sample layout. Upon assembling my board, I was able to flash it exactly one time using...
I've just built the slm_lte_modem application using SDK 2.2.0. I've also programmed modem firmware 1.3.4 into the device. I have access t the AT command set and most of them...
Hi Sirs,
in nRF5340, is it doable for to adjust the power index of different channels of BLE_1M or 2M, in terms of SW code (if there is then where? or NVRAM like setting...
Hi,
after the manual installation the Quick Setup of nRF Connect for VS Code says
that GNUARMEMB_TOOLCHAIN_PATH and ZEPHYR_TOOLCHAIN_VARIANT environment variables are...
Hi,
I'm using nrf9160dk and i want to run HTTPS_CLIENT example to send some ping.
when i run the HTTPS_CLIENT I'm getting error:- " getaddrinfo() failed, err 0 "
i haven...
This question is all about massaging CMake I guess, but I cannot get any clear answers from the CMake documentation. Here is my problem:
I have a NCS based project that...
Hello,
I'm using the nRF52832 product, nRF5_SDK_15.3.0_59ac345, and the android S21 mobile phone as a back-end system. I'm working on ble_app_bps, ble_app_gls, and ble_app_hrs...
Hello everyone, I'm using the secure_bootloader example to load the application into my device. I need to detect bootloader progress, can anyone tell me how? I would like...
The documentation states that SB2 must be cut and SB1 soldered.
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fug_nrf52840_dongle%2FUG%2Fnrf52840_Dongle%2Fhw_power_ext_reg_source...