I was working with IAR and SDK10.0 before. For some reason I have to transfer my project to Keil and SDK9.0. My program worked well for the old settings. While keeps got NRF_ERROR_SOC_NVIC_INTERRUPT_NOT_AVAILABLE...
Currently we are considering whether we should use external Flash Memory or NRF52 Internal Flash.
External Flash memory has a lot of drawback in comparsion with internal...
Suppose there are 10 BLE peripherals in a room and one BLE Central,then is there any way i can get the list of available peripherals[name or id.. etc]?
I am using NRF5182...
I am using SDK_11 s130 on nrf51-dk. When err_code is any value other than NRF_SUCCESS, APP_ERROR_CHECK(err_code) will cause nRF51-dk board to reset. How can one get APP_ERROR_CHECK...
Hello All,
I have problem with ble_app_uart which are not support DFU services.
When I am implement both services device will not advertise. and when ble_nus uninitialized...
[symptom]
I want to update my application/bootloader/softdevice by DFU.
Steps are shown below.
bootloder/softdevice update
if 1 step is done, application update...
Dear Developer Zone,
I am new to ANT and am looking for someone to help me to setup an example 15 channel (14 devices) ANT network using the S332 soft-device to test communication...
Hello,
I am developing using NRF52832 and nRF5_SDK_15.2.0.
I am using FDS to manage some data.
Size of each data will be 20bytes. I like to store maximum 1000 data...
Hi,
We modified the lte_ble_gateway example and connected to our aws iot server. And have faced few issues so far and would like to get some hint from you.
We are using...
This question was asked, not answered, and locked. So I will ask it again
I changed the security settings on a CCCD for a heart rate measurement characteristic and got...
Hello,
I have troubles with the timer interrupt. The code work fine until the timer hit the compare value and then stop.
This is my function for the timer init:
Here...
Hi,
I have a problem with the BLE mesh light example using the static provisioner. I have modified the example to have multiple Generic OnOff servers. Client and Servers...
Hi, I'm a beginner of Firmware Engineering and facing an issue on programming of sensor module.
I am using a sensor as IIS2DLPC made by STM, and board is nrf52840 dk board...
I am re-starting a project to send MQTT topics to AWS. At this point, is MQTT_Simple still the best way to start and then modify the endpoint as suggested in case 224855 or...
When i call the sd_ble_gap_adv_start function then after a few seconds the mesh communication fails because the scanner_radio_irq_handler is not called/triggered anymore....
Dear,
I started a new laptop Windows 10 Pro
installed nRF Connect, and followed the Started Assistant
installed the toolchain
downloaded the SES (v4.20a)
----...
I have NRF5252840-DK (evaluation board, SDK 15.3.0, S140) acting as central. It correctly scans advertising data from my peripheral - custom board with NRF52811 (same SDK...
Hello,
I am working on nRF9160 DK development platform.
For that i Compile & run GPS example, But while debuging that example i find that mcu stucks in CPU Idle function...
Hi,
I am currently trying to program an external module using the nordic nrf52840 development kit debug output pins. I have the following connections that I have taken from...
