Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
Hi!
I'm trying to configure my NRF8001 module with the help of nRFgo studio. I'm using Nordic UART over BTLE service template. The module can be discovered via nRF Master...
Hi,
I am working on a project that involves 2 nrf52840 DKs. One device will be running a ble application while the other device will be lookin, fetching and programming...
In SDK 1.4 we combined the udp and GPS examples and the result is unstable.
I think this could be because once enabled by RRC mode == Idle, GPS keeps going forever.
After...
Hi,
I have an issue with using the %XRFTEST command for TX testing on the LTE-M network. My setup consists of the nRF9160 DK (PCA10090) with the MFW 1.2.3 and a 1NCE SIM...
hello,
i am using two customised nrf52840 boards to get maximum range between the boards using this example https://github.com/NordicPlayground/nRF52-ble-long-range-demo...
I have update the SDK from version 1.4.2 to 1.5.0.
Suddenly i see that the hci_rpmsg is not build as a child image.
Which defines do i need to set for that now?
Hi,
Currently, we work on a project that uses:
nRF9160
Zyphre OS
Segger Embedded Studio for Arm (Nordic Edition) V5.10d
SDK v1.4
CONFIG_NEWLIB_LIBC=y
CONFIG_NEWLIB_LIBC_FLOAT_PRINTF...
Hi Team,
I am trying to build a project for nrf52810 and I selected an example project from the below given path.
nRF5_SDK_17.0.2_d674dde\examples\peripheral\blinky\pca10040e...
Hi, I've been working with the nRF9160 and at some point the logs normally displayed in LTE link monitor were gone. I've tried re-installing the Link Monitor but it didn't...
I'm trying to merge the ble_Central example project with ble_app_template project. I've added 3 Custom services in the ble_app_template project by setting UUIDs and trying...
Hello,
I am working on a nrf52833 custom board. Most of the time, the system stays in sleep mode, and periodically sends bursts of data via SoftDevice.
I try to configure...
I am using bootloader based on Nordic secure bootloader example. I would like to add possibility to identify device after entering BLE DFU. I was thinking about device MAC...
Device : nrf52840
Platform : baremetal
Peripherals in use :
Softdevice
FDS
SAADC
RTC
I am using FDS Library to Write Data whenever an event is generated...
