Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
We have sensor data coming at regular interval of 40B at 10msec interval. We need to collect it for a minimum of 10 sec before we can process it and then reuse the same buffer...
Hi
Apologies in advance if my terminology is all wrong for the following question.
I am trying to write some i2c functions that will compile / work for any of I2C peripherals...
Hi, Im trying to write a simply python script to allow connect, write data, read data and disconnect from my targeted bluetooth device using nRF52840-Dongle.
Basically I...
Hi,
I am trying to set up PWMs on a custom board, but I am not able to observe the outputs using an oscilloscope (pins are constantly at 0V). The PWM channels should be...
Hi,
I have a BLE OTA application and I try to send data with the nRF52840 dongle and a Python application using the pc_ble_driver for Python. I have tested my MCU application...
Hi,
When I try to build zephyr\samples\modules\tflite-micro\hello_world from nRF Connect 2.1.0 on VS code for nRF5340, it didn't build. I get errors like,
cpp:19:10: fatal...
Hello
I built the nrf dm sample for the nrf52840dk_nrf52840 target and loaded it on 2 nrf52840 dev kits
Tried both MCPD and RTT methods
No matter what the distance between...
I did some searching through the samples and could not find any that use indications rather than notifications. I did find some references in other posts that are like 8 years...
Has a community member implemented and fabricated the nRF5340 IC in the WLCSP package that has its pad landings spaced at a 350um ?
If so, can you share design guidelines...
Dear community
I'm new to the nRF9160 and to cellular connectivity related functionality.
We're in the concept phase of a product that implements cellular cloud connectivity...
hi team.
i have one doubt.which type of temperature sensor used in nrf52840.you mentioned in nrf52840 data sheet just temperature sensor.but which type it is thermocouples...
Hi,
I have looked at the "mass" example showing how to expose a fatfs via USB MSC, that looks good.
I want to do this, but using the QSPI flash storage.
Is there an...
Hello,
I have a couple of Adafruit Feather nrf52840 express devices and I want to set up a small openthread network. As far as setting up a simple network where all the...
