Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
MPU6050 cannot calculating the value of 3 axis and the value return is 0. What is problem? How can I fix it ? Thanks for helping me. AD0 open.Adress is 0x68
Here is my...
Hi，everyone：
I tried HSS mode, but it can't meet my needs.
When I use RTT mode, the configuration is as follows
test code:
RTT viewer:
but, J-scope has been...
Hello All,
I have ported the UART example ( <InstallFolder>\examples\peripheral\uart ) on top of blinky in nicla sense hardware. The TX is working only when rx pin is set...
Hi,
I'm trying to build a proof of concept for a BLE gateway that captures data from BLE sensors and sends it to the cloud via LTE-M connection. I'm hoping that the gateway...
Hi, we are developing a project based on the LWM2M client, everything is working fine but now we need three non volatile variables. We did some testing with the nvs example...
Hello,
I have recently been able to connect to multiple sensors using the nrf connect 2.0.0 SDK and nrf 52840 dongle as a central device. I was wondering how I could configure...
Hi,
I would like to create a multiprotocol BLE/Zigbee coordinator project on NRF5340 with VScode.
I can't find an exemple nor guide on this except from this one:
https...
What does this error mean?
here is my error massage.
<info> app_timer: RTC: initialized. <info> app: Debug logging for UART over RTT started. <info> app: Connected <error...
Hi, Does anyone know the quiescent/average power consumption of the IBasis sim card. I have a design based on the Thingy:91 and I am wondering if it is worth moving from the...
Hi, I'm developing an project that using 2 UARTE. My code flow is 1. when timer handler has expried ( set timer_expired_flag = true) (using app_timer) 2. Enable uarte1 to...
I have 2 custom boards running as BLE central/peripheral.
The peripheral is running the beacon broadcast example from SDK 17, ble_app_beacon.
The central is running custom...
I'm working with an custom application and a bootloader with code drawn from the examples in SDK 15.2.0. The main method of my bootloader is below:
I can run and debug...
Hi Community,
I want to use the UART Logging backend in my bootloader. Whenever I want to start the actual application via nrf_bootloader_app_start(), the bootloader hangs...
