Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
I am trying to get std::vector to work on nRF52840 running Zephyr in Visual Studio Code running v2.7.0 toolchain , but have been unable to do so. I found some similar tickets...
Hi nordic
I've try to enable 115200 baud UART on p0.9 and p.10 but I can't make it.
I just saw a thread about 52840 can't use 115200 uart at p0.9, p.10:
https://devzone...
Hello,
Is it possible to use the filtering options provided by the nRF52840 BLE sniffing firmware for Wireshark, in Tshark? Specifically the device address filtering....
Hello, I have two questions. 1. First, are these pins reserved in the SOC level or DK level? this if from the nrf52840dk device tree. meaning, if I have a custom board, should...
Hello,
I'm using an nRF52840 on a custom board operating in high voltage mode, powered either by a LiPo battery or USB. The design follows configuration 4 from the nRF52840...
bt_mesh_dfu_metadata_encode always adds comp_hash and elems fields to the buffer
However the bt_mesh_dfu_metadata_decode function checks if the fw_type is
BT_MESH_DFU_FW_CORE_TYPE_APP...
Hi Nordic DevZone Community,
I am currently working on a BLE peripheral application using the Zephyr stack and have encountered an issue where my device stops advertising...
Hi,
I am using SDK v2.6.1 with the nrf7002dk_nrf5340_cpuapp board.
My HTTPS code works fine, but when I try to merge the configuration files for BLE, ADC, WebSocket, and...
I am performing OTA of nRF52840 with BLE. It is working fine but device takes around 20 seconds to reboot after OTA image data is transferred to nRF52840 via nRF device manager...
Hi, I use nRF52840 DK (SDK 2.5.0), all my attempts to raise examples for "Matter", were not crowned with success (for example projects: Light Bulb, Light switch). Everywhere...
Hi all, We are using nRF Connect Application to discover Bluetooth device implemented on nRF52840 MCU. Company identity data is set within the manufacturer specific data sent...
