Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
I created xml file for heartrate server using bluetooth developer studio and the plugin nRF8001_Arduino (plugin nordic semiconductor for arduino)
the generated xml file...
I read this older post ( devzone.nordicsemi.com/.../) and have a similar issue but with enough differences that I felt it was worth a new question.
I have an STM32 MCU...
Hello Nordic Support!
About on-chip access method to Flash memory of nRF52832 please tell me. It is necessary to store calibration data in non-volatile memory (Flash)...
Hi,
I am a newbie and just strted first evaluation with nRF52832 board. I am using SEGGER IDE.
The example i am using is: C:\nordic_semi\nRF5_SDK_15.3.0_59ac345\examples...
I am trying to use the Watchdog on the nRF52840 as a means to check state of the application via different variables. If I see the application in a bad state, I would like...
Hi all,
I have a trouble about understanding.
As far as I understand, when Device 1 send service change indication to Device 2, Device 2 will rediscovery service of Device...
it seems that SDK 15.2 is missing the uint64_t cast for the reload_value calculation again.... or am i missing something? we use a 5 minute value, which does not work unless...
I try to DFU operation.
SDK15.3.0 / GCC / nrf52840
My application image size is 123,484bytes (nrf52module.bin)
I run command ,
nrfutil.exe pkg generate --hw-version...
Hello All,
I am working on nRF51822 using IAR IDE and nRF51 SDK 12.3.0.
Right now I am checking power consumption of device in ideal mode but right now it is higher. ...
Hello. I tried to understand MMA8652FC Acceleration sensor with 52832.
I don't know what means 16Hz, 8Hz, etc. under table.
I know just concept of High pass filer. that...
Hi, I want to use wolfssl library on nrf51822 and I'm in stuck.At first, I compiled wolfssl as arm-none-eabi ,then added the static lib to the project in segger studio.
...
Hello everyone!
I'm trying to build a project of gathering the information from several temperature/pressure/humidity sensors and sending it to one display.
Sensors will...
Hi, I've tried to set BLE power to max but an app error is raised when I use the sd_ble_gap_tx_power_set function. Parameters should be wrong but as far as I've read over...
How do I align UART transmission/reception with GPIO pin signaling low/high? I wanted to do this because BLE chip is receiving the Product ID & device name from microcontroller...
