Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Hi, I am currently using the PPK2 for current measurements.
According to the datasheet, the PPK2 supports a maximum source voltage of 5 volts. However, my device requires...
Hello
we are certifiying our product by ISO 13849-1 which includes the Nordic nRF52832, among more information I would like to start with the following questions
1. where...
Dear nordic support
We're in the concept phase of a product that implements cellular cloud connectivity.
We already implemented a "blueprint" ESW which provides supporting...
Hi,
I am planning to create an ultrasonic library (based on ch201) because I can't find any library for it. So I am porting code from ch201 development kit to nrf52 custom...
Hi there,
I have a Thingy:91 board and I would like to enable the accelerometer data to be sent to nRF cloud when using the Asset tracker v2 application. I saw that it is...
Good afternoon,
I'm trying to understand how the RTC works on the nRF52.
The RTC can run when HFCLK is OFF and PCLK16M is not available
Section 25.5 describes the TICK...
It appears that KConfig is uable to find any compilers for native_posix with VS Code on windows 10 after installing all recommended packages and prerequisites during SDK install...
Hello,
I am using LwM2M library in my project and I want to check what version I am using of LwM2M carrier library. Please correct me if I am wrong, is according to below...
I am creating software for a proof-of-concept device using the nRF52840 Dev Kit and nRF Connect for VS Code.
I started a few weeks ago with the Nordic UART Service code...
With Zephyr, I am using BLE Stack sample (rpc-host) on net core and peripheral_uart on app core. I changed the uart pins on from the standard dvk configuration on devicetree...
Hi
I was wondering why there there seems to be no information about profiling of the LC3 codec by T2.
Only information I found is from Karl's answer here :
The rule...
Hi~ I have a new NRF52832 REV3 xxAA board, and I need to read its SRAM value. However, when I use the JLink command to read it, I get 0. I have tried recover and eraseall...
I have the occasional issue where connecting VDD to VTG either on P20 or shorting SB24 will cause the nRF9160 DK to brown out. This happens when an external device to be programmed...
Good day everyone
I'm attempting to build a temperature sensor on i2c am running into this error. Currently using a custom board. I see that the issue was previously mentioned...
