[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Softdevice Version： 8.0.0
SDK： 9.0.0 IC：
NRF51822 Rev 3
service： NUS ANCS
When the application is not downloaded, the bootloader is working.
After serial bootloader...
I'm building a project for the nRF52832 using the NRF5-SDK version 14.0.0. I'm compiling using GCC 6.3.1 ( arm-none-eabi-gcc (GNU Tools for ARM Embedded Processors 6-2017...
Hello,
We are using the AWS library on a Thingy91 to enable FOTA. We have a working example where we store the bin file in S3 as instructed in the SDK documentation.
Now...
Hello, I am trying to use the Peripheral UART code with the nRF9160-DK. I followed this guide https://devzone.nordicsemi.com/nordic/nrf-connect-sdk-guides/b/getting-started...
Dear All, I was wondering if you could provide any examples or advice as to good practice techniques when using the Watchdog timer in a multi-threaded Zephyr application.
Hi all,
I'd appreciate some help on the following problem:
I'm trying to put a custom hardware into a low power sleep mode from which I want to wake up regularly. I’m...
Hello
I am doing a project need to implement firmware update from the application
and I reference bellow thread,
https://devzone.nordicsemi.com/f/nordic-q-a/68368/write...
Hi, I am trying to build the light switch server in the nRF for Mesh SDK, but I cannot generate the SES build files using cmake.
I am receiving the following error
CMake...
My central and peripheral are continuously connected at 1sec connection interval to conserve power on both devices.
When a button is pressed, I would like to exchange data...
I don't fully understand datasheet for LFXO.
17.4.3
CL_LFXO Load Capacitance = 12.5pF. Is this the recommended CL for external crystal?
RS_LXFO ESR = 100k. Is this the...
Hello everybody,
I'm developing a webapp that need to communicate with my BLE device, an nRF52 DK Board.
The firmware has some open and some encrypted characteristics...
