Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
hi team,
i have trying to wrote a code for saadc module in segger 5.40 using nrf52840 controller. whenever i am trying to increase the Acquisition time the sampling value...
Hi, I want DFU the NRF52840 using the UART. Please let me know the following quires .
Process-
I want to create two partition of memory one will store the my main application...
While running the mentioned code I am getting stack overflow error continuously. Can someone help me understand the reason behind that and what can be done to resolve such...
Hi, I am trying to do the SPI communication between a SPI master and two SPI slaves. I am using NRF52840 Dev Kit as SPI master and 2 ESP32-S3 as SPI slaves. I am using SDK...
I have added WDT to the blinky_freertos sample.
And I am debugging with SEGGER ozone.
building with SDK17:
If you reset the software in the debugger and start it,...
I have this 2,4" TFT Display with a IL9325 driver! I need to implement a 8bit 8080 Parallel interface.
image description
This is my 8 bit write function:
// Write...
I have this as nrf52840dk_nrf52840.overlay in my application directory:
/ {
lightStrings {
compatible = "gpio" ;
lightString0: lightString_0 {
gpios = <& gpio0...
Dear Sirs!
I am going to use nrf_drv_spi_xfer to read 15 bytes periodically (Approximately each 4 ms) according to GPIO (GPIOTE Event via PPI). To do it I am going to call...
I'm attempting to use a vendor or custom model to deliver sensor data through a ble mesh using a nrf52840dk board. On Ubuntu, I'm using the nrf connect sdk v2.2.0. i have...
Hi,
We are using the nordic sdk 1.9.1.
I have created my own project and i want whole sdk commit to my repo. I am able to build the project. I am not able to commit the...
Hello Guys,
I am trying to implement our own firmware update over ble in Mobile App.
The whole process is succesfully done by Nordic Application (Device Manager).
I...
Hi,
I'm implementing a circuit that uses both ble and usb communication using nRF52840.
I'm configuring power source and i'll configure schematic like reference circuit...
Hi there.
I am currently developing a simple asset tracker based on several examples using nrf9160 custom board.
So I am using several examples like mqtt_simple, gnss...
