to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hey there,
We are currently evaluating the nPM1100 to power several circuits (nrf52, IMU, LEDs).
Our device is tiny, and we want to use a coin-cell battery ( ML2020 from...
Hello,
I am using EMDS to store data to flash under certain conditions. The implementation is pretty basic and follows the specification and example in the SDK (v2.1.2)...
Hello nordic team ,
We are using nrf5340 DK and below mentioned are the Specifications used:
1) Visual studio code
2) nRF5340-DK hardware board (PCA10095)
3) Flash...
Hi,
I am currently trying to use SPI for the nrf9160. I tried building the SPI_BITBANNG sample for the nrf9160dk_nrf9160_ns board for the nrf9160dk that I have.
However...
Hello everyone,
Can someone help confirm if the Timer and PWM modules on nRF52840 can only use the high frequency (HF) clock source (1 MHz or higher) and cannot run from...
Hello,
update to NCS2.2.0,VScode, nRF5340DK
C:\ncs\v2.2.0\zephyr\samples\bluetooth\periodic_sync\
no change any code,got error,
*** Booting Zephyr OS build v3.2.99...
Hello,
I am using the nrf52 for development purposes, during the development I need to power cycle the device approximately ~1000 times, no flash writes in between. Does...
Hi,
for device power managment, i want to power down/disable uart0 that is being used by the Peripheral UART sample. it is giving errors when doing it via the .conf and...
Ive been trying the last few Sdk versions to evaluate the matter examples without luck. With 2.2 released yesterday I jumped on that hoping it would clear up my issue, but...
i have been practicing normal built in application from https://academy.nordicsemi.com/lessons/lesson-1-nrf-connect-sdk-introduction/ . While moving to the next stages i discovered...
Hello,
I've purchased nRF52840 DK 3.0.0 2022.34 1050279741 and device protection remains after power up, even if I disable it.
Current behaviour :
1. nrfjprog...
Hello developers, I am using nRF52833 chip for Mesh sensor application.
The picture below is my mesh network model. 1. The model includes devices such as Sensor Server,...
When trying to compile a zigbee light switch example for the nrf5340-cpu_app target using visual studio using the zigbee fota prj file, the application compiles only once...
brief:
The Zigbee version fo the example was ported to matter. Both standards use ZAP files for the definitions, but have smaller differences in their specification. The...
