In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
I need repetitive Timer and Edge Counter in my application. There is is a single Timer Peripheral that can be used either as a Timer or Counter. As well, further in counter...
I am developing an NRF52833 application that reads from the I2C sensor MLX90641. Below is the code I am using to test. MLX90641_I2C_Driver.c was originally written for Mbed...
Dears
Th case ID of my old question is 218372.
I were waiting for two weeks. However, nobody responded to me.
I wanted to make a BLE mesh product used NRF52840 and NRF21540...
Hi support team
I'm now based on ncs1.9.0 platform. I check the file "\nrf\samples\bluetooth\direction_finding_connectionless_tx\README.rst", finding that the board nrf52811...
I am working on a project with nrF9160dk to connect with AWS IoT cloud, when I was trying to update the certificate by using LTE Link Monitor, why I am getting errors when...
Hello, I tried to using the nRF Connect SDK with VS Code, however when it seems there are some problem while I trying the build. I have read the similar post and trying to...
Why is it that when I try to build assert_tracker_v2 for thingy53_nrf5340_cpuapp or nrf5340dk_nrf5340_cpuapp I get:
Blinky builds fine.
Also, cleaning projects tend...
Hi,
I've made my own PCB with an nrf52840. Right now I'm hoping to test out the bluetooth and measure my board's power consumption - the only problem is that I can't reliably...
Hello,
I can not find a good example online on how to properly configure nRF9160 DK for i2c. In order to learn the system, I am testing a simple example with the nrf9160...
I just install the NCS in toolchain manager, but after installation, only one toolchain folder is there,no zephry,no examples,
I'm going to play in VSCode.
what should...
I use nRF5340 DK as Central, iPhone as Peripheral.
I start a scan with no filters and in scan_filter_no_match() I check if RSSI is good enough "RSSI > -45" and initialize...
