Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
Hello all,
I'm trying to connect to custom Board with nRF52840 controler.
nRFgo Studio (V:1.21.2.10) gives error "No device detected, or readback...".
I've also tried...
Hi there!
I have the following setup:
A Raspberry Pi 3 B and a nRF52840 Development Kit acting as a Border Router as described in the official documentation ;
Another...
Hi!
I would like to know if it is possible to use the nRF52840 to read a mifare classic 1k card?
If it is, is there an example for this?
Thanks!
Andreas
I am currently developing a code that will serve as my pulse sensor. I am now trying to write the code in VScode, for it is very appealing to me. The problem now arises with...
Hey
This is sumanth. I have worked on light switch example with server, client and mobile as provisioner. I would like to develop a mesh network where the server has to...
history: https://devzone.nordicsemi.com/f/nordic-q-a/44018/softdevice-invalid-memory-access-info-0x2/172932#172932
compiler: keil
To solve the hardfault issue (SOFTDEVICE...
Hi guys,
is it possible to print in blocking mode by request?
I tried to use a return value from SEGGER_RTT_printf(0, "some text\n"); but the value is always the same...
I have many nRF24LE1E chips that have a corrupted Info Page. I use the Dataman-48Pro2 programmer. I have read and saved the Info Page from a working chip but have not been...
nRF5 SDK for Mesh v3.1.0
SEGGER Embedded Studio
Softdevice S140 v6.1.0, Softdevice S132 v6.1.0
Two nRF52832 DK, One nRF52840 DK
Windows 10 Pro
Hi, is it possible...
Hello,
I have a nRF9160 DK Development kit, and I would like to use it to replace an Arduino uno.
I need to do Analog to Digital Conversion on A0, A1, A2.
I need to...
Hi,
I currently try to build a little thread network with a border router bridging to ethernet. I did everything like in the Border Router Quick Start Guide and as far as...
Hello guys,
I am trying to work on an advertisement model where I have a transmitter(nRF52832 DK) which should advertise specific data only for certain amount of time say...
