But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hello
I am a product development team leader and mobile (iOS, Android) app developer.
Our product uses NUS to control the product.
Currently, encryption is not applied...
Hello,
I'm trying to compile the examples\dfu\secure_bootloader\pca10040e_s112_ble_debug\ses project, I have modified the flash placement according to the memory layout...
Hi,
I am trying to program nRF52840 dongle (PCA10059) with PlatformIO and Arduino framework, but the program (see below) won’t start. I think it falls in the hard fault...
Setup:
nrf connect sdk version v2.1.2
board: nrf52840DK
Trying to send a beacons for half a second whenever I get some specific data on uart, and also send data over...
Hi,
We have multiple controllers connected serially(using SPI/UART) to the NRF5340 controller in our product. We have a requirement to download multiple images(4-5) for...
We are working with adafruit Nrf52832 and have a weird problem, the Ground pin and 3.3v pin is shorted and it also shows a 3.3v between them. Can you please help regarding...
Hi there,
I wanted to bring up the Bluetooth samples on NRF5340 development kit on NRF CONNECT SDK v2.2.0.
After building and flashing it, I can see the UART log on my...
Under:
https://developer.nordicsemi.com/nRF_Connect_SDK/doc/2.2.0/nrf/ug_thread_tools.html#configuring-a-radio-co-processor
steps listed for 1 and "nRF52840 Dongle (USB...
Hello,
I am starting working on a nRF9160DK board, but I am new to this and I am a bit lost.
Using the Dev Academy course and example, I was able to make a small project...
Looking at the docs: nrf/ug_thread_architectures.html
I see the note "This platform design is currently discontinued by nRF Connect SDK." for "Network co-processor (NCP...
Hi All,
We have 2nos. of NRF5340 DK board, in which we are trying to run the "broadcast_audio_source" from nrfConnect SDK 2.2.0 sample installed from nrf Connect desktop...
hi team,
i have trying to wrote a code for saadc module in segger 5.40 using nrf52840 controller. whenever i am trying to increase the Acquisition time the sampling value...
Hi, I want DFU the NRF52840 using the UART. Please let me know the following quires .
Process-
I want to create two partition of memory one will store the my main application...
While running the mentioned code I am getting stack overflow error continuously. Can someone help me understand the reason behind that and what can be done to resolve such...
