It is possible to run easily a SoftDevice stack (e.g. S110) on nRF51422 using an accurate 16MHz external clock reference for HFCLK instead of an external 16 MHz crystal oscillator...
I want to change data bytes in the advertisement packet. In ACI_DEVICE_STANDBY I put: lib_aci_open_adv_pipe(1);
In ACI_EVT_CMD_RSP: I get feedback that command 1B (I assume...
first,PCA10005 can't load sofeware hex that after s110 7.0.0 hex(include 7.0.0),and gostudio note that the given hex file can not open successfully.
second,the PCA10005...
Hello! I'm using sdk8 and s110. I want my peripheral device to send data to the central. I doing following steps:
1. initialize service:
void services_init(void)
{...
We are evaluating a number of Thingy:91 to track GNSS positions and reporting them to nRF Cloud using the Asset Tracker V2 firmware. When running the Asset Tracker in Active...
We are seeing an issue where we are connecting to an LTE/GPS chip via interrupt UART. Things work great until have an irregular amount of time, communication to the LTE chip...
I have 4 rencet nRF52-DK boards. The sticker on the MCU says "PCA10040 / v3.0.0 / 2022.14). I want to switch them to the DAPLink firmware, and to do so I need them to enter...
I can capture NRF_GPIOTE_POLARITY_TOGGLE event now. But how can I capture NRF_GPIOTE_POLARITY_LOTOHI and NRF_GPIOTE_POLARITY_HITOLO events.
The following is log messages...
Hi,
I want to implement AoA feature for our BLE beacons. I understand that I should add a CTE field to the packet, and rest of the job will be done by the receiver. Please...
I have plan to use Raspberry pi as a central device and my BLE nRF52840 Dongle as a peripheral device.
I am testing the peripheral with ble_app_hrs example. The dongle could...
Hi，
The product is used in a humid environment, found that the 52832 chip sleep current becomes large, from 30uA to 80uA, now has disconnected all external pins only retain...
I have enabled mcuboot and have two boot partitions: primary and secondary. I'm using a static flash configuration. I want to start using the settings subsystem for persistently...
Dear ,
I am currently using NCS1.8.0.
I noticed that there was warning message as shown below after I downloaded the program to my custom board via my nRF52 dev kit. ...
Board: nRF52833
SoftDevice: s122
SDK version: 17.0.2
I'm trying to log my continuous sensor data from the peripheral on the serial monitor. So I took ble_app_uart_c...
I have a compiling program when using the stock nRF52840dk_nrf52840.dts file, it outputs to the USB port to a serial terminal on a comm port.
As soon as i use my custom...
hello Nordic
i am working with nrf52832, with zephyr, ncs v1.7.1,
the device has a sensor that sample at 26khz each sample is 3 channels of 2 bytes data. the sensor use...
