But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hi，
Our products encountered some problems when doing air upgrades.
chip: nRF52832
sdk: 17.0.2
The picture above is the switch circuit part of our schematic...
Hi, I'm using nRF52832 ble_app_uart example project. In ble_gap.h file, I could see:
From my understanding, the number 4 means that the variable sm (security mode) will...
Hi,
I tried to change my UUID in the BLE_APP_UART program.
After changing I am not able to connect my NRF UART app with my device.
How do I solve this?
I'm working on NCS 1.6.1.
i plan to use a SPIS with an IRQ pin .
i refered to a sample "hci_spi" in SDK , dts is as follows.
&spi1 { compatible = "nordic,nrf-spis";...
Hi,
I would display a picture on my lcd screen. I use the driver st7735, with PCA10040 and my IDE is segger embedded. I find the documentation of nrf_gfx_bmp565_draw ...
I have a problem, like this fellow engineer here , but the solution is not applying for me.
More specifically here our function calls from application is like this:
...
This is not an official Nordic library related but I'm hoping someone could help. I'm using the Radiohead library http://www.airspayce.com/mikem/arduino/RadioHead/ And i got...
Hello,
I'm in a developing stage with the nrf52840 and today I got this error after trying to ensure the " --erase all " command from the nRF Connect software.
I know...
Hi all,
I using SDK 15.2 with our customised board and i have already done ota for nrf52832 sucessfully
But i cant do the same for nrf52810
nrfutil pkg generate -...
Hello there. I'm currently looking at the sniffer software
https://www.nordicsemi.com/Products/Development-tools/nRF-Sniffer-for-Bluetooth-LE/Download?lang=en#infotabs ...
Hi,
I'm using nrf52840 and connect to a PC with BLE, using Nordic Uart Service (Rx and Tx characteristics).
When sending messages, I need to know how much data I'm writing...
