This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hi,
Are there any examples or references available to read / write data into the external SD card using fs_read, fs_write?
The examples available in older SDKs are not...
hi support team,
NCS SDK is now available, customer need to use cmd line tool to build demo and flash;
but find out that we have to open cmd through "nrf connect--->toolchain...
Hi,
I'm having difficulty getting a clean MCK when configuring passthrough (bypass) mode. I'm using ACLK as the source and I do get a 12.288MHz signal on the MCK pin but...
Hi all
In development with nRF91 and my application need to using an external flash memory to store the firmware and I try to follow the example this link below.
https...
Hi, I'm developing an application using internal flash memory. I based on flash_fds example to implement this feature. Now I can write and read data from flash. My basic feature...
Hi,
I have a board using an off the shelf nrf52811 module (from raytac). The only things on the board are the recommended 32k crystal with 2x 12pF caps, as well as two...
Hello,
I've been trying to get my call to app_uart_put() to actually place bytes on the TX pin. Interestingly enough, my call to app_uart_get() works fine and is able...
Am currently trying to implement a client UDP socket application with Mbed DTLS using a Pre Shared Key.
PSK and PSK_ID array values are defined as:
static const unsigned...
Hi,
I am using Thingy 91 in Australia, and I have linked Asset Tracker v2 with overlay-lwm2m.conf to communicate with my own LwM2M server, which is running an instance of...
I'm working towards getting an app derived from MQTT Simple to talk to AWS where I both need to validate the hostname via TLS, and also use public/private certificates to...
Several have asked about this basic situation but I have found no definitive answer.
I erased a dongle with a Segger J-link, and compiled the zephyr samples using CONFIG_BOARD_HAS_NRF5_BOOTLOADER...
My set up is nRF52832 with a board very much like the PCA10040. The SDK is version 16.0.0. I am using Segger Embedded Studio version 5.60 and I am using the GCC compiler suite...
My goal is to have my boot loader write a constant value to RAM and have my applicaton read that same location and retrieve that value.
I am using the stock boot loader...
