We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hello
I hope someone can help with my problem.
We have a small to large BT Mesh network and we want to use the URI value to send preliminary information from the node...
I am working on nRF52833 board (PCA10100). I am pairing my peripheral device ( Nordic Board ) to the Mobile Application. I have to disable pairing after a certain timeout...
Hi all,
It's my first post here so hello everybody!
I'm quite new in BLE5, but I have been playing with BLE4 some years ago (around 12) and I want to confirm some...
Hi Nordic
When I use JLINK to burn the firmware to the nRF52832 chip in the device, some devices cannot be programmed or cannot be programmed again after burning once
...
Hello, I've stumbled about a problem with the NrfConnect extension and Kconfig. It is quite simple: When a project directory contains a Kconfig file, it is used by west as...
I'm a bit confused by the "unidirectional" solutions offered as examples / documentation for the nRF5340 DK. I would like to build a BLE Audio headset that both receives and...
Hi
How is the ESB_EVT_IRQHandler started? NVIC_SetPendingIRQ(ESB_EVT_IRQ) is registered with on_radio_disabled(), but I don't know how to be started this handler in the...
Hi:
I use ncs 1.9.1, borad nRF9160-DK
sda-pin = <30>; scl-pin = <31>;
Config:
I added i2c2 in blinky, here is the source code.
I see i2c2 enabled in...
Hello,
I am experiencing issues with an nRF5340 DK. I would like to try the matter samples but every time I flash one of them, it results in fatal error and reseting loop...
fota_download_start copies the file but not host string into a static buffer. The comment implies that the download_client only requires this for the file path, though it...
