Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi,
I have used a Joulescope DC energy analyser to measure the current and power consumption of the nRF52833 DK. I took measurements to see how different TXP powers and...
Hello, I am working on direction finding connectionless locator/beacon (AoA). I ran into a problem in the locator. Everything works fine until "Waiting for periodic sync....
Hello Devzone,
I'm developing a Zigbee gateway using NRF52840 and ESP chip for wifi. NRF52840 it act as an coordinator.
I'm using nrf5_sdk_for_thread_and_zigbee_v4.2.0_af27f76...
Hello All,
I have a problem when I build my project from sample central_uart & peripheral_uart .
I have two nrf5340 called A and B . B scans the broadcast to A to establish...
Hi，
Application core can run serial port printing. then creat copy to net core ，Burn separately to the each core can work fine。Then I merged the two projects into one, and...
I have been attempting to install nRF Connect SDK on macOS for several months without complete success. You can check my prior tickets for details. Nonetheless, I have recently...
Hey!
My current setup is using an Android tablet ---- BLE ----> MCU1 (nrf52840) ---- BLE----> MCU2 (nrf52832)
I'm setting the MCU1 to act as both a peripheral and central...
Hello,
I'm trying to evaluate using the zephyr hci_usb sample as a temporary solution to connecting to several ble sensors. I have modified the prj.conf to allow multiple...
I used the nRF52840 SDK 15.3.0 dfu secure_bootloader uart example to develop a custom bootloader. I have checked that my application file is correct by trying it without the...
MCU: nRF52840
IDE: Keil uVision 5.17
SDK: 15.2.0
Board: Custom
OS: FreeRTOS
Using MicroLIB
Hello,
I am currently working on a FreeRTOS project that leverages...
Hi,
Based on the below extract:
"Because older devices that don’t support Bluetooth 5 will not be able to discover extended advertisements, an advertising set with legacy...
Hi, I am currently using the PPK2 for current measurements.
According to the datasheet, the PPK2 supports a maximum source voltage of 5 volts. However, my device requires...
Hello
we are certifiying our product by ISO 13849-1 which includes the Nordic nRF52832, among more information I would like to start with the following questions
1. where...
Dear nordic support
We're in the concept phase of a product that implements cellular cloud connectivity.
We already implemented a "blueprint" ESW which provides supporting...
