Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hi,
I am trying to build a keyboard with Media Button inputs as well. I tried to add consumer HID to the keyboard HID but it does not work.
The thing which i want to know...
Hi,
I am trying to integrate the fat_fs and peripheral_uart example, but unable to do so because of the SD card initialization error. Both examples are working fine separately...
Hello Dear;
I'm developing a low power phy beacon device. But my device current consumption is about 0,7mA. After sending an advertisement, the current consumption should...
We manufacture boards based on an NRF52832 and we have an abnormally high rate of BLE faults during tests at the end of production. In order to determine if the problem comes...
Hello,
i'm experiencing a issue regarding receiving UDP responses from our COAP server. Our server implements a piggy back response scheme, however in some cases it is either...
hello
i'm use the nRF5_SDK_17.1.0 and nRF52DK.
I am developing using SDK example , "ble_app_hids_keyboard".
There is only one problem I have to ask.
Check out the...
Hi,
in the ticket here it was reported that the fix for the external flash problem was supposed to be fixed in 2.1.0.
Is that still the goal ?
Can i kindly have an estimation...
Hi,
I'm using nRF52805. I need to advertise BLE continuously according my application but also have to reduce power consumption because device is battery operated.
Currently...
Hi,
today I faced a rather strange problem when trying to restart the SAADC.
Bit of context: a requirement for the product I'm developing changed and the device now must...
Hello,
Can raw data be published via MQTT with SLM 1.7?
In later versions we have done this by entering data mode, which we see is not implemented here.
Is there another...
I'm using the nRF52832 in an energy harvesting application, where I need to cold-start the device and set a GPIO output high in under 50ms in order to latch the power supply...
When using AT command to send data, the baud rate is set to 9600, and the two modules are connected at different temperatures, and the data is sent through the serial debugging...
Hello everyone
The company I work for produces an nRF52840 based dongle.
We also have a bootloader which is a modified sdk example.
We need to save some important data...
I'm trying to install nrf-command-line-tools_10.17.0_amd64.deb on an up to date Debian 11, but dpkg always fails with this error:
# dpkg -i nrf-command-line-tools_10.17...
