Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hi,
I am using
nRF52832
SDK 15.3.0
The soft device is S132
JLinkRTTViewer for debug
I am making dfu using ble.
After all downloads are finished, the board...
Hello,
I have a problem witch border router (based on rpi) configuration. In rpi there is a wpan0 interface to thread and eth0 for ethernrt. I need to establish communication...
Hi,
I would like to write a string to flash in mqtt_simple SDK example using latest modem firmware and ncs v1.4.0. I based my code off the zephyr example (samples/subsys...
I have a NRF52840 device which advertises connectable every 2 seconds for unlimited time.
I'm running a custom service (based mostly on this code https://github.com/NordicPlayground...
Hi Team,
we are using the Nrf52840 board for our development. We are facing one issue with RAM Structure Corruption.
We have one Global structure in our code, in that...
Good morning,
I have my BLE application developed on the nRF52840 and S140.
My application is perfectly working and I'm able to bond (pin required) any Android smartphone...
To the kind attention of Nordic support team,
Our product should be able to establish encrypted ble connections using passkey (the strongest security level in ble) and...
Hello,
I am trying to use multiple Nordic USB dongles to perform multiple DFUs simultaneously. I've found with the help of Nordic FAEs and through some testing that spreading...
I have MAX17043 c and cpp library how to include it in the new project file in Segger Embedded Studio. Whenever i try to create my own project and try to compile it gives...
Hello all,
I use a nrf9160. In my program, I would like to use a watchdog to be sur than my application is running.
1. I would like to save some data in memory without...
I just downloaded nRF SDK 17.0.2 and installed Segger Embedded Studio V5.20a
I opened the blinky example for the nrf52840 (C:\Nordic\nRF5_SDK_17.0.2_d674dde\examples\peripheral...
Hi everyone!
I got a Nordic Thingy 91 and I have tested the sample Asset Tracker application. But now, I want to build and program my own application, I was reading this...
I have a problem with a call to sd_ble_gattc_read() made within on_primary_srv_discovery_rsp that is reading vendor service UUID and returns with NRF_ERROR_BUSY. I am following...
