After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Hello All,
I have 2 evaluation boards nrf52840 EVB "PCA10056".
I would like to run on them the "ble_app_uart" in "nRF5_SDK_15.3.0_59ac345" as following:
A custom board...
I used nrf52832 to port the program from SDK14.2 to SDK15.2 and there was a problem. In SDK 15.2, the program functions normally in the online debugging state, but the function...
I like to use 2 server boards and 1 client board in mesh as custom model. Is it possible to use client to communicate with 2 or many server's without using instance in client...
Hello,
I am trying to conenct the DK to the nRF cloud. I registered the SIM successfully and then proceeded to insert the sim and power up the unit. The LED 3/4 sequence...
Hi there! I am looking to implement a Zigbee powered device using the nRF52840. I have very good hardware knowledge of said chip, but not so much of the software part (especially...
In the documentation for app_uart_init() - there is a statement indicating:
Function for initializing the UART module. Use this initialization when several instances...
device addr：38 D2 69 BB B9 E7
The address type returned by the nrf_ble_scan_address_type_decode function is BLE_GAP_ADDR_TYPE_RANDOM_PRIVATE_NON_RESOLVABLE。
The type...
Hello Nordic Support!
About on-chip access method to Flash memory of nRF52832 please tell me. It is necessary to store calibration data in non-volatile memory (Flash)...
Hi,
I am a newbie and just strted first evaluation with nRF52832 board. I am using SEGGER IDE.
The example i am using is: C:\nordic_semi\nRF5_SDK_15.3.0_59ac345\examples...
I am trying to use the Watchdog on the nRF52840 as a means to check state of the application via different variables. If I see the application in a bad state, I would like...
Hi all,
I have a trouble about understanding.
As far as I understand, when Device 1 send service change indication to Device 2, Device 2 will rediscovery service of Device...
it seems that SDK 15.2 is missing the uint64_t cast for the reload_value calculation again.... or am i missing something? we use a 5 minute value, which does not work unless...
I try to DFU operation.
SDK15.3.0 / GCC / nrf52840
My application image size is 123,484bytes (nrf52module.bin)
I run command ,
nrfutil.exe pkg generate --hw-version...
