Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
Hi I'm using nrf52DK board with SDK 14.02. I wanted to use PWM Library with softdeivce but I'm getting this <error> app: ERROR 3735928559 [Unknown error code] at E:\nRF5_SDK_14...
I have a Raytac module which contains a nrf52810 AT module in it hooked up to a micro via Uart, so i can send and receive AT commands and data. I'm trying to connect to my...
Hi, I have developed one custom application and enabled DFU features in it.
With the help of nRF Toolbox mobile application, I am changing the application code.
Now I...
I just installed the nRF9160 DK but it showed yellow exclamation marks at the CDC and BULK interfaces. I'm using Windows 7. I couldn't find where these drivers are.
Anyone...
How do I use PWM on a GPIO on port 1 on SDK 15.2? The PWM library examples only sends in the pin number and seems to assume port 0. This answer seemed a bit complex and I...
Dear all,
I modified the example "ble_app_uart" based nRF5_SDK_15.2.0_9412b96 and S132 SoftDevice v6.1.0 to do some tests . But now I encounter the disconnect reason 0x22...
Hi guys, help me please.....
I want to build a device act like both keyboards and mouse. I've made some progress that the device can connect to my PC(win10) successfully...
Hi all
I developed my custom NRF52840 pcb followed by nordic design..i have done program flashing.Blinky LED also working.But Beacon advertising is not working.while flashing...
Dear Sir
I was working with nrf52832.
.SDK version ------------- 'nRF5_SDK_15.0.0_a53641a'
Soft device - s132_nrf52_6.0.0_softdevice.hex
I was handling a scenario...
I measured the consumption of nrf52832, in deep sleep mode, the consumption is 32uA, the question is: there is a pulse about 5mA every 39ms, is that all right? what's the...
In the screenshot above, although the CMSIS 5.4.0 SoftPack is installed, when compiling, it means that there is no SoftPack.
And I notice deprecating support for CMSIS Pack...
Hello,
I've just been following this tutorial for beginners about advertising. I've got it to work fine. I am able to advertise specific data and this can be viewed through...
