Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Was using SDK 1.9.1 up till now, but I migrated to SDK 2.0.0 and I changed my overlay file to add the pin control stuff. I have a nrf5340 and use the app_ns board config....
According the data written to NVM, is there a difference between "%XFSSYNC" and "+CFUN=0" ?
Reading the documentation, I see mainly user configuration be written.
I may...
Hello,
I am trying to add SDCard management, over SPI bus, into my project with nRF5340. When I try to compile, the error is always the same. I am trying the code over the...
Hello,
I have a problem that looks a bit like
devzone.nordicsemi.com/.../nrf52840-custom-board-won-t-boot-without-debugger-reset
For me, to be more precise:
nRF52840...
I just upgraded my environment from nRF Connect SDK v1.9.1 to v2.1.0. This process raised one critical bug, as well as some very important questions:
My projects make very...
The setup : nrf 52840 , NCS 1.9.1 , The SAADC is configured in advanced mode with 1 single end channel and double buffered with size of 16 (32bytes). RTC is configured to...
Hi,
I am reposting this as the previous question might have been closed due to inactivity from my side and the issue isn't resolved yet.
To follow up please check this...
Hello,
In BLE-Mesh models, we have APIs like:
To send data to other devices on the Mesh.
Here I observed that the context "struct bt_mesh_msg_ctx *ctx" stores...
Hello,
I am trying the BLE llpm code and made some changes in the existing sample code in the data length to 8 bytes from 4 bytes.
When transmitting a data of 8 bytes...
Hello,
Could you tell me the reference of the Li-po connector on the nRF5340-DK development board?
Indeed I would like to connect a Li-po battery to power this board....
There are at least several show-stopper level issues with your nRF Connect SDK and VS Code for M1 Mac users
First not supporting the native VS Code app is annoying and forces...
Hello,
i'm using nRF5 SDK 17.0.2and nRF5 SDK for Mesh v5.0.0 using the examples light switch client and server.
I am trying to triggen or simulate a button press on client...
Dear Nordic Engineers
I have a question would like to ask you.
As we all know, NRF9160 DK has a 64MB external flash. Now, I would like to use this external flash to save...
