Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
I've been continuing to work on why my power level seemed low after getting the Skyworks FEM in my Fanstel BT840x module going, per this thread:
So far, I've been setting...
I want to increase the rate of data from UARTE to RF FIFO.Can data be transferred from the cache to the RF FIFO using DMA?
nrf52832 nRF5_SDK_17.1.0_ddde560 S132
Hello, I am trying to understand the adc example using the PCA10056.
HI can see the following code that initializes 3 `zephyr_user` channels
In the DT file,...
Hi,
I recently went through the manual installation instructions for the nRF Connect SDK posted here ( https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/gs_installing...
Dear,
I would like to remove the DCDC converter in between the li-ion cell which is supplying the system and the system.
The idea is to use our micro battery as the...
Hi All, I have the same issue than in this thread :
To explain fastly, I am using the pc_ble_driver_py v0.15.0, with a nrf52840 Dongle to try catching voice sent by a device...
Getting this issue while building the code I have tried these given options but did not worked out . Please help me with this. I have included all the required driver files...
Our Setup
STM32 Chip (master) connected to nRF52840 (slave) via UART
STM32 is supposed to update the application on n RF52840
nRF52840 runs the secure UART bootloader...
Hi There,
I am currently developing the firmware for a peripheral device using the NRF52840 and NCS V2.0.0.
At the moment everything is working as expected except for...
Hello,
I'm evaluating using the opus library included as a of the "nRFready Smart Remote 3 nRF52" as a part of our zephyr based application. We only need to decode stored...
Hi,
I've installed "nRF Connect for Desktop v3.12.0" on Win 10 (Version 21H2, Build 19044.2006) and then installed the Programmer v3.0.4 out of nRF Connect. Installation...
Hi Nordic Guys,
hope you can help following issue (I think the issue is still mentioned in Ticket https://devzone.nordicsemi.com/f/nordic-q-a/87410/corrupt-matter-zcl...
Dear,
I have integrated the nrf5_calendar example with "usbd_ble_uart" . Everything works correctly, but I have detected two possible errors (or I am doing something wrong...
